SF2193E Datasheet, PDF (1/5 Pages) RF Monolithics, Inc – 1228 MHz SAW Filter

SF2193E
• RF Filter for GPS Receiver
• Surface Mount 3.0 x 3.0 mm Package
• Complies with Directive 2002/95/EC (RoHS)
Absolute Maximum Ratings
Rating
Input Power Level
DC Voltage on any Non-ground Terminal
Operating Temperature Range
Storage Temperature Range in Tape and Reel
Maximum Soldering Profile, 5 cycles/10 seconds maximum
Pb
Value
5
3
-30 to +85
-40 to +85
265
Units
dBm
V
°C
°C
°C
1228 MHz
SAW Filter
Electrical Characteristics
Characteristic
Center Frequency
Insertion Loss, 1218 to 1238 MHz
Amplitude Ripple, 1218 to 1238 MHz
Attenuation, 0 dB Reference:
0 to 1088 MHz
1088 to 1178 MHz
1178 to 1190 MHz
1268 to 1288 MHz
1288 to 1378 MHz
1378 to 1480 MHz
1480 to 2500 MHz
2500 to 4000 MHz
Source Impedance, Unbalanced
Load Impedance, Balanced
Case Style
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 Inch
Reel Size 13 Inch
Sym Notes
Min
F_C
IL
Typ
1228
3.4
0.9
SM3030-8
Max
4.4
1.7
Units
MHz
dB
dB
40
52
32
50
15
50
13
29
dB
30
41
36
54
28
47
13
20
Z_S
50
Ω
Z_L
50
SM3030-8 3.0 x 3.0 mm Nominal Footprint
906, YWWS
500 Pieces/Reel
3000 Pieces/Reel
Electrical Connections
Dot Indicates Pin 1
Connection
Unbalanced Input
Balanced Output
Ground
Terminals
2
5, 7
All Others
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4. "LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes."
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
7. US and international patents may apply.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
www.RFM.com E-mail: [e-mail]
©2009-2010 by RF Monolithics, Inc.
Page 1 of 5
SF2193E - 7/19/10