SF2176E Datasheet, PDF (1/6 Pages) RF Monolithics, Inc – 433.92 MHz SAW Filter

Preliminary
• Low-loss RF SAW Filter
• Surface-mount 3.0 x 3.0 x 1.3 mm Package
• Complies with Directive 2002/95/EC (RoHS) Pb
Absolute Maximum Ratings
Rating
Input Power Level
DC Voltage on any Non-ground Terminal
Operating Temperature Range
Storage Temperature Range in Tape and Reel
Solder Reflow Temperature, 10 seconds, 5 cycles maximum
Electrical Characteristics
Characteristic
Center Frequency
Maximum Insertion Loss, 433.12 to 434.72 MHz
Amplitude Ripple, 433.12 to 434.72 MHz
VSWR, 433.12 to 434.72 MHz
Attenuation Referenced to 0 dB:
10.00 to 380.00 MHz
380.00 to 423.42MHz
443.42 to 453.42 MHz
453.42 to 460.00 MHz
460.00 to 700.00 MHz
700.00 to 1000.00 MHz
Source Impedance
Load Impedance
Case Style
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 Inch
Reel Size 13 Inch
SF2176E
Value
10
3
-40 to +85
-40 to +85
260
Units
dBm
V
°C
°C
°C
433.92 MHz
SAW Filter
SM3030-6
Sym Notes
Min
F_C
IL_MAX
Typ
433.92
2.2
0.4
1.6:1
Max
2.9
1.0
2.0:1
58
61
46
50
25
30
35
40
50
54
42
46
Z_S
50
Z_L
50
SM3030-6 3.0 x 3.0 mm Nominal Footprint
A09, YWWS
500 Pieces/Reel
3000 Pieces/Reel
Units
MHz
dB
dB_P-P
dB
Ω
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4. "LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes."
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
7. US and international patents may apply.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc
www.RFM.com E-mail: [e-mail]
©2011 by RF Monolithics, Inc.
Page 1 of 6
SF2176E - 1/17/11