SF2059B-1 Datasheet, PDF (1/5 Pages) RF Monolithics, Inc – Low Insertion Loss

• Low Insertion Loss
• 5.0 x 7.0 mm Surface-Mount Case
• Complies with Directive 2002/95/EC (RoHS)
Absolute Maximum Ratings
Rating
Maximum Incident Power in Passband
Maximum DC Voltage Between any 2 Terminals
Storage Temperature Range
Maximum Soldering Temperature
Pb
Value
+10
Units
dBm
30
VDC
-40 to +85
°C
265°C for 10 s
SF2059B-1
137.50 MHz
SAW Filter
Electrical Characteristics
Characteristic
Nominal Center Frequency
Minimum Insertion Loss
1 dB Bandwidth
3 dB Bandwidth
Amplitude Ripple, 137.1 to 137.9 MHz
40 dB Bandwidth
Operating Temperature Range
Input and Output Impedance
Case Style
Lid Symbolization (YY=year, WW=week, S=shift) See note 4
SMP-03
Sym
f_C
IL
BW₁
BW₃
T_A
Notes
1
1, 2
1
1, 2
1
5
Min
Typ
Max
Units
137.50
MHz
8.3
9.1
dB
0.80
0.86
1.0
MHz
0.85
1.3
dB_P-P
7.0
MHz
-40
+85
°C
L-C Match to 50 ohms
SMP-03 7 x 5 mm Nominal Footprint
RFM SF2059B-1 YYWWS##
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. The design, manufacturing process, and specifications of this filter are subject to change.
4. Tape and Reel Standard Per ANSI / EIA 481.
5. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
6. US and international patents may apply.
7. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
8. ©Copyright 2009, RF Monolithics Inc.
www.RFM.com E-mail: [e-mail]
©2009 by RF Monolithics, Inc.
Page 1 of 5
SF2059B-1 - 1/16/09