SF1223D Datasheet, PDF (1/6 Pages) RF Monolithics, Inc – 800/842 MHz SAW Duplexer

Preliminary
• Surface Mount 3.8 x 3.8 x 1.4 mm Package
• Complies with Directive 2002/95/EC (RoHS)
Absolute Maximum Ratings
Rating
CW Input Power Level, 50,000 hours, +50 °C
DC Voltage
Operating Temperature Range
Storage Temperature Range in Tape and Reel
Pb
Value
0.5
0
-30 to +85
-40 to +85
Units
W
V
°C
°C
SF1223D
800/842 MHz
SAW Duplexer
Electrical Characteristics, Transmitter, 842.0 MHz
Characteristic
Center Frequency
Insertion Loss, 832.0 to 852.0 MHz
Amplitude Ripple, 832.0 to 852.0 MHz
VSWR, 832.0 to 852.0 MHz
Attenuation Referenced to 0 dB, 790.0 to 810.0 MHz
Input Impedance (Antenna)
Output Impedance, (TX and RX)
Case Style
Lid Symbolization (Y=year, WW=week, S=shift) dot=pin 1 indicator
Standard Reel Quantity
Reel Size 7 Inch
Reel Size 13 Inch
Sym
F_C
IL
Z_S
Z_L
Notes
Min
Typ
Max
842.0
2.0
3.0
0.8
1.6:1
1.5
2.2:1
45
50
50 (L-C Match)
50 (L-C Match)
SM3838-12 3.8 x 3.8 x 1.45 mm Nominal Footprint
939, YWWS
1000 Pieces/Reel
3000 Pieces/Reel
Units
MHz
dB
dB_P-P
dB
Ω
CAUTION: Electrostatic Sensitive Device. Observe precautions for handling.
Notes:
1. Unless noted otherwise, all specifications apply over the operating temperature range with filter soldered to the specified demonstration board with impedance
matching to 50 Ω and measured with 50 Ω network analyzer.
2. Unless noted otherwise, all frequency specifications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout and external
impedance matching design. See Application Note No. 42 for details.
4. "LRIP" or "L" after the part number indicates "low rate initial production" and "ENG" or "E" indicates "engineering prototypes."
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port 1 and Port
2, so that the filter must always be installed in one direction per the circuit design.
7. US and international patents may apply.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc
www.RFM.com E-mail: [e-mail]
©2009 by RF Monolithics, Inc.
Page 1 of 6
SF1223D - 9/21/09