SF1090A Datasheet, PDF (1/6 Pages) RF Monolithics, Inc – 350 MHz SAW Filter

• Designed for WLAN IF Applications
• Low Insertion Loss
• 9.1 x 7.1 mm Surface-mount Case
• Unbalanced Input and Output
• RFM Standard-Connection Version of SF1090A-1
• Complies with Directive 2002/95/EC (RoHS)
Pb
Absolute Maximum Ratings
Rating
Maximum Incident Power in Passband
Max. DC voltage between any 2 terminals
Storage Temperature Range
Suitable for lead-free soldering - Max. Soldering Profile
Value
Units
+10
dBm
30
VDC
-40 to +85
°C
260°C for 30 s
SF1090A
350 MHz
SAW Filter
SM9171-10
Electrical Characteristics
Characteristic
Nominal Center Frequency
Passband
Insertion Loss at fc
1 dB Passband
3 dB Passband
Group Delay Variation over fc ±600 kHz
Rejection
fc-2.0 to fc-1.8 and fc+1.8 to fc+2.0 MHz
fc-7.0 to fc-2.0 and fc+2.0 to fc+7.0 MHz
At < fc-7.0 MHz and > fc+7.0 MHz
Operating Temperature Range
Sym
f_C
IL
BW₁
BW₃
GDV
T_A
Impedance Matching to 50 Ω unbalanced
Case Style
Lid Symbolization (XX = 2 character date code)
Notes
Min
Typ
Max
1
350.000
10
13.0
1, 2
±500
±600
±880
1, 2, 3
30
<100
200
40
50
1
-20
+70
External L-C
SM9171-10 9.1 x 7.1 mm Nominal Footprint
RFM SF1090A XX
Units
MHz
dB
kHz
ns_P-P
dB
°C
Electrical Connections
Connection
Port 1 Hot
Port 1 Gnd Return
Port 2 Hot
Port 2 Gnd Return
Case Ground
Terminals
10
1
5
6
All others
Notes:
1. Unless noted otherwise, all specitication apply over the operating temperature range with filter soldered to the specified demonstration board with
impedanced matching to 50 Ω network analyzer.
2. Unless noted otherwise, all frequency specitications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent oon PCB layout
and external impedance matching design. See Application Note No. 42 for details.
4. “LRIP” or “L” after the part number indicates “low rate initial production” and “ENG” or “E” indicates “engineering prototypes.”
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port
1 and Port 2, so that the filter must always be installed in one direction per the
circuit design.
7. US and international patents may apply.
8. Electrostatic Sensitive Device. Observe precautions for handling.
RF Monolithics, Inc. Phone: [phone]
Fax: [phone]
RFM Europe
Phone: [phone]
Fax: [phone]
©2001 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc.
E-mail: [e-mail]
http://www.rfm.com
SF1090A-121504
Page 1 of 2