SF1063A Datasheet, PDF (1/11 Pages) RF Monolithics, Inc – 549.00 MHz SAW Filter

• Designed for CATV Applications (Pilot Tone)
• Low Insertion Loss
• 9.1 x 7.1 mm Surface-Mount Case
• Unbalanced Input and Output
• Complies with Directive 2002/95/EC (RoHS) Pb
SF1063A
549.00 MHz
SAW Filter
Absolute Maximum Ratings
Rating
Maximum Incident Power in Passband
Max. DC voltage between any 2 terminals
Storage Temperature Range
Suitable for lead-free soldering - Max Soldering Profile
Value
Units
+10
dBm
30
VDC
-40 to +85
°C
260°C for 30 s
SM9171-10
Electrical Characteristics
Characteristic
Nominal Center Frequency
Passband
Insertion Loss at fc
Sym
f_C
IL
Notes
1
Min
Typ
Max
549.000
7.5
9.0
Units
MHz
dB
Rejection
0.5 dB Passband
3 dB Passband
Amplitude Ripple over fc ±100 kHz
529.04 MHz to 545.75 MHz
BW_0.5
BW₃
1, 2
1, 2, 3
±100
40
±630
kHz
dB_P-P
0.5
ns_P-P
551.4 MHz to 569.04 MHz
35
dB
Ultimate
50
Operating Temperature Range
T_A
1
-20
+85
°C
Impedance Matching to 50 Ω unbalanced
Case Style
Lid Symbolization (XX = 2 character date code)
External L-C
SM9171-10 9.1 x 7.1 mm Nominal Footprint
RFM SF1063A XX
Electrical Connections
Port 1 Hot
Port 1 Gnd Return
Port 2 Hot
Port 2 Gnd Return
Case Ground
Connection
Terminals
10
1
5
6
All others
Notes:
1. Unless noted otherwise, all specitication apply over the operating temperature range with filter soldered to the specified demonstration board with
impedanced matching to 50 Ω network analyzer.
2. Unless noted otherwise, all frequency specitications are referenced to the nominal center frequency, fc.
3. Rejection is measured as attenuation below the minimum IL point in the passband. Rejection in final user application is dependent on PCB layout
and external impedance matching design. See Application Note No. 42 for details.
4. “LRIP” or “L” after the part number indicates “low rate initial production” and “ENG” or “E” indicates “engineering prototypes.”
5. The design, manufacturing process, and specifications of this filter are subject to change.
6. Either Port 1 or Port 2 may be used for either input or output in the design. However, impedances and impedance matching may vary between Port
1 and Port 2, so that the filter must always be installed in one direction per the circuit design.
7. US and international patents may apply.
8. RFM, stylized RFM logo, and RF Monolithics, Inc. are registered trademarks of RF Monolithics, Inc.
9. Electrostatic Sensitive Device. Observe precautions for handling.
RF Monolithics, Inc. Phone: [phone]
Fax: [phone]
RFM Europe
Phone: [phone]
Fax: [phone]
©2001 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc.
E-mail: [e-mail]
http://www.rfm.com
SF1063A-112904
Page 1 of 3