English
Language : 

IC1003 Datasheet, PDF (1/11 Pages) RF Monolithics, Inc – RF Uart
• Provides RF Uart Functions, 12 Bit Symbols to Serial TX
• And Serial RX to 12 bit Symbols with Start Symbol Detection
• Supports data rates from 100Kbps to 1Mbps
• Allows unsquelched receiver operation for improved sensitiviy
• Compatible with RFM’s TR-Series ASH transceivers
The IC1003 RF Uart IC detects a start-of-data pulse sequence and then provides
clocking pulses in the middle of each following data bit. The IC1003 is designed to
support a host protocol processor which can be in sleep mode until interrupted into
active operation by the start-of-data detect pulse. The IC1003 is compatible with RFM's
2nd generation ASH transceivers and receivers and allows these radios to operate with
no threshold for improved system sensitivity.
Absolute Maximum Ratings
Please refer to the latest revision of Xilinx data sheet for the XC9572-7VQ64
IC1003
RF Uart
IC
Characteristic
Supply Voltage
Supply Current
At 40Mhz Clock(1Mbs Data)
Logic Low Input
Logic High Input
Logic Low Output
Logic High Output
Supported Data Rates:
Sym
VDD
IDD
Notes
VIL
VIH
VOL
VOH
Minimum
3.0
0.8
VDD - 0.7
100
Typical
48
Maximum
3.5
0.2
0.6
1000
Transmitted Bit Rate Tolerance
±1
Operating Temperature Range
-40
85
Units
V
mA
VDD
VDD
V
V
Kbps
%
°C
RF Monolithics, Inc.
RFM Europe
Phone: (972) 233-290
Phone: 44 1963 251383
Fax: (972) 387-8148
Fax: 44 1963 251510
©1999 by RF Monolithics, Inc. The stylized RFM logo are registered trademarks of RF Monolithics, Inc.
E-mail: info@rfm.com
http://www.rfm.com
IC1003-050103
Page 1 of 11