DNT90CA Datasheet, PDF (1/7 Pages) RF Monolithics, Inc – 900 MHz Frequency Hopping Spread Spectrum Transceiver

- 900 MHz Frequency Hopping Spread Spectrum Transceiver
- Point-to-point, Point-to-multipoint, Peer-to-peer and
Store & Forward Capabilities
- Transmitter Power Configurable to 40 or 158 mW
- Built-in 0 dBi Chip Antenna
- 100 kbps RF Data Rate
- 128-Bit AES Encryption
- Separate Serial Port for Diagnostics
- Analog and Digital I/O for Sensor Applications
- FCC and Canadian IC Certified for Unlicensed Operation
The DNT90CA/PA FHSS transceiver modules provides a low-cost, versatile solution for wire-
less data communications in the 900 MHz ISM band. The DNT90CA/PA RF output power can
be set at 40 or 158 mW. The DNT90CA/PA receiver input is protected by low-loss SAW filter,
providing an excellent combination of receiver sensitivity and out-of-band interference rejec-
tion. The DNT90CA/PA modules include analog, digital and serial I/O, providing the flexibility
to serve applications ranging from cable replacements to sensor networks. The built-in chip
antenna makes these modules very easy to integrate.
DNT90CA
DNT90PA
Low Cost
900 MHz FHSS
Transceiver
Module with
I/O
DNT90CA/PA Absolute Maximum Ratings
Rating
Power Supply Input
All Input/Output Pins
Non-Operating Ambient Temperature Range
Value
-0.5 to +6.5
-0.5 to +3.3
-40 to +85
Units
V
V
o_C
DNT90CA/PA Electrical Characteristics
Characteristic
Operating Frequency Range
Hop Duration
Number of RF Channels
Modulation
RF Data Transmission Rate
Receiver Sensitivity @ 10^-5 BER
Transmitter RF Output Power
Optimum Antenna Impedance
Antenna
System Topologies
Access Scheme
Sym Notes
1
1
1
Minimum
Typical
Maximum
902.76
927.24
8
100
25, 26 or 52
FSK
100
-100
40 or 158 mW
50
0 dBi Dielectric Chip Antenna
Point-to-Point, Point-to-Multipoint,
Peer-to-Peer and Store & Forward
Ad Hoc TDMA
Units
MHz
ms
kbps
dBm
mW
Ω
www.RFM.com E-mail: [e-mail]
© 2012 by RF Monolithics, Inc.
Page 1 of 6
DNT90A - 05/10/12