LCL2112-L Datasheet, PDF (1/3 Pages) RFHIC – MCM LNA

MCM LNA
LCL2112-L / LCL2312-L
LCL2712-L
Product Features
• Multichip Hybrid Module
• GaAs p-HEMT & MESFET chip on board
• No matching circuit needed
• High IP3 & Low Noise
• Single Supply Voltage (+5V)
• Surface Mount Hybrid Type
• Tape & Reel Packaging
• Small Size, High Heatsink
• Alumina Substrate
• Pb Free / RoHS Standard
Applications
• 2G & 3G Repeater
• Base Station
• PCS, CDMA, W-CDMA
• GSM, DCS, UMTS
• WiMAX, Wibro, WLAN
• RF Sub-Systems
Package : CP-16B
Descriptions
RFHIC’s LOW Noise Amplifier series are all hybrid LNA type products which includes all matching for the convenience of
customers. LCL series are focused on higher OIP3 while maintaining low noise. The structure of the device is built with GaAs p-
HEMT die attached on a ceramic thick film substrate. The device is still smaller than the area one would use for the application
notes all together. Depending on the part number, one can use this in different frequency applications. All LNA hybrids are
possible to have custom frequency & spec without any additional NRE cost involved.
All RFHIC products are RoHS compliant.
Electrical Specifications
Parameter
Units
LCL2112-L
LCL2312-L
LCL2712-L
Frequency Range
MHz
1920~2170
2300~2400
2300~2700
Small Signal Gain (S₂₁)
dB
24.8
22
20.5
Gain Flatness
dB
±0.7
±0.5
±0.7
Input Return Loss (S₁₁)
dB
-15
-15
-14
Output Return Loss (S₂₂)
dB
-15
-15
-14
1dB Compression Point (P₁dB)
dBm
21
20
20
Output 3^rd Order Intercept Point
(OIP3) (TYP.)
dBm
42
41
40
Noise Figure (TYP.)
dB
0.8
1.0
1.0
DC Supply Current (Vdc=+5V)
mA
180~240
180~240
180~240
Test Condition
① Supply voltage = +5V, 50ohm System, Ta = 25℃
② OIP3 is measured with two tones, at an output power of +10dBm/tone separated by 1MHz.
▪ Tel : [phone]
▪ [e-mail]
page 1/3
▪ All specifications may change without notice.
▪ Version 6.1