CL0902-L Datasheet, PDF (1/5 Pages) RFHIC – Low Noise Amplifier

CL0902-L / CL1502-L
Low Noise Amplifier CL1802-L / CL2102-L
Product Features
• GaAs p-HEMT chip on board
• No matching circuit needed
• High Maximum input power(+25dBm)
• High IP3 & Low Noise
• Single Supply Voltage (+5V)
• Surface Mount Hybrid Type
• Tape & Reel Packaging
• Small Size, High Heatsink
• Alumina Substrate
• Pb Free / RoHS Standard
Applications
• 2G & 3G Repeater
• Base Station
• PCS, CDMA, W-CDMA
• GSM, DCS, UMTS
• WiMAX, Wibro, WLAN
• RF Sub-Systems
Package : CP-16A
Descriptions
RFHIC’s LOW Noise Amplifier series are all hybrid LNA type products which includes all matching for the convenience of
customers. CL series are focused on giving lowest noise possible. The structure of the device is built with GaAs p-HEMT die
attached on a ceramic thick film substrate. The device is still smaller than the area one would use for the application notes all
together. Depending on the part number, one can use this in different frequency applications. All LNA hybrids are possible to have
custom frequency & spec without any additional NRE cost involved.
All RFHIC products are RoHS compliant.
Electrical Specifications
Parameter
Frequency Range
Small Signal Gain (S₂₁)
Units
CL0902-L
CL1502-L CL1802-L CL2102-L
MHz
824~894
(Cellular)
890~960
(GSM)
1400~1600 1700~2000 1850~2200
dB
21
20
17
16
15
Gain Flatness
dB
±0.5
±0.5
±0.5
±0.5
±1.0
Input Return Loss (S₁₁)
dB
-17
-17
-17
-18
-18
Output Return Loss (S₂₂)
dB
-8.5
-8.5
-10
-10
-10
1dB Compression Point (P₁dB)
dBm
20
20
21
21
20
Output 3^rd Order Intercept Point
dBm
31
31
33
33
33
(OIP3) (TYP.)
Noise Figure (TYP.)
dB
0.7
0.7
0.6
0.6
0.6
DC Supply Current (Vdc=+5V)
mA
100
100
90
100
100
Test Condition
① Supply voltage = +5V, 50ohm System, Ta = 25℃
② OIP3 is measured with two tones, at an output power of +0dBm/tone separated by 1MHz.
▪ Tel : [phone]
▪ [e-mail]
page 1/5
▪ All specifications may change without notice.
▪ Version 6.2