CL0901-L Datasheet, PDF (1/8 Pages) RFHIC – Low Noise Amplifier

CL0901-L / CL1501-L
Low Noise Amplifier CL1801-L / CL2101-L
Product Features
• GaAs p-HEMT chip on board
• No matching circuit needed
• High Maximum input power(+25dBm)
• High IP3 & Low Noise
• Single Supply Voltage (+5V)
• Surface Mount Hybrid Type
• Tape & Reel Packaging
• Small Size, High Heatsink
• Alumina Substrate
• Pb Free / RoHS Standard
Applications
• 2G & 3G Repeater
• Base Station
• PCS, CDMA, W-CDMA
• GSM, DCS, UMTS
• WiMAX, Wibro, WLAN
• RF Sub-Systems
Package : CP-16A
Descriptions
RFHIC’s LOW Noise Amplifier series are all hybrid LNA type products which includes all matching for the convenience of
customers. CL series are focused on giving lowest noise possible. The structure of the device is built with GaAs p-HEMT die
attached on a ceramic thick film substrate. The device is still smaller than the area one would use for the application notes all
together. Depending on the part number, one can use this in different frequency applications. All LNA hybrids are possible to have
custom frequency & spec without any additional NRE cost involved.
All RFHIC products are RoHS compliant.
Electrical Specifications
Parameter
Frequency Range
Small Signal Gain (S₂₁)
Units
CL0901-L
CL1501-L CL1801-L CL2101-L
MHz
824~894
(Cellular)
890~960
(GSM)
1400~1600 1700~2000 1850~2200
dB
19
18
16
15.5
14
Gain Flatness
dB
±0.5
±0.5
±0.5
±0.5
±1.0
Input Return Loss (S₁₁)
dB
-18
-18
-18
-18
-18
Output Return Loss (S₂₂)
dB
-10
-10
-10
-10
-10
1dB Compression Point (P₁dB)
dBm
14
14
15
16
16
Output 3^rd Order Intercept Point
dBm
27
27
27
27
27
(OIP3) (TYP.)
Noise Figure (TYP.)
dB
0.5
0.5
0.7
0.6
0.7
DC Supply Current (Vdc=+5V)
mA
65
65
45
45
45
Test Condition
① Supply voltage = +5V, 50ohm System, Ta = 25℃
② OIP3 is measured with two tones, at an output power of +0dBm/tone separated by 1MHz.
▪ Tel : [phone]
▪ [e-mail]
page 1/8
▪ All specifications may change without notice.
▪ Version 6.2