LS2101M2G220300 Datasheet, PDF (1/2 Pages) RFE international – ALUMINUM ELECTROLYTIC CAPACITORS LS2 Series: Snap-In, Fail Safe, 85C

ALUMINUM ELECTROLYTIC CAPACITORS _RoHS
LS2 Series: Snap-In, Fail Safe, 85°C
ü
FEATURES
• Snap-in, 2000 Hrs, 85°C
• Fail-Safe, will fail open without flame if excessive voltage is applied
• RoHS Compliant
SPECIFICATIONS
Items
Operating Temperature Range
Capacitance Tolerance
Leakage Current (at 20°C)
Performance
-40°C ~ +85°C
+20% (at 120Hz, 20°C)
I = 0.02CV or1.5 mA whichever is smaller (after 5 minutes)
Where, C= rated capacitance in µF. V= rated DC working voltage in V.
Dissipation Factor
(Tan at 120Hz, 20°C)
Low Temperature
Characteristics (at 120Hz)
Load Life Test
Shelf Life Test
Ripple Current &
Frequency Multipliers
Ripple Current &
Temperature Multipliers
Safety Fundtion Test
Conditions
Other Standards
Rated Voltage 200 250
400 450
Tan (max) 0.15 0.15 0.20 0.20
Impedance ratio shall not exceed the values given in the table below.
Rated Voltage
200 250 400
450
Impedance
Z (-25°C)/Z(+20°C)
448
8
Ratio
Z(-40°C)/Z(+20°C)
8 10 18
20
Test Time
2,000 Hrs
Capacitance Change
Within +20% of initial value
Dissipation Factor
Less than 200% of specified value
Leakage Current
Within specified value
* The above specifications shall be satisfied when the capacitors are restored to 20°C after
the rated voltage applied for 2,000 hrs at 85°C
Test Time
1,000 Hrs
Capacitance Change
Within +20% of initial value
Dissipation Factor
Less than 150% of specified value
Leakage Current
Within specified value
* The above specifications shall be satisfied when the capacitors are restored to 20°C after
exposing them for 1,000 hrs at 85°C without voltage applied. The rated voltage shall be
applied to the capacitors before the measurements (Refer to JIS C 5102)
Freq.
(Hz) 50/60 120
W. V. (V)
10K
300 1K
up
Multiplier 0.8
1.0
1.1 1.3 1.4
Temperature
40
60
70
85
( C)
Multiplier 1.8
1.4
1.2
1.0
1. DC reverse voltage test:
The capacitor is shall be connected in reverse polarity, and applied under
specified working voltage.
2. DC over voltage test:
The rated voltage of 1.2 times shall be applied to the capacitor.
JIS C 5101-4
PART NUMBER EXAMPLE
LS2 101 M 2G 220 300
SNAP-IN TERMINAL TYPE
Terminal Lengh:
Blank = 6.3mm
A = 4.0mm
Case Size (22mm X 30mm)
Rated Voltage (400V)
Capacitance tolerance (±20%)
Capacitance (100mF)
Series name
L+2 Max
6.3+1
RFE International • Tel:[phone] • Fax:[phone] • E-Mail [e-mail]
C1CH03
2009.8.3