M37212M4 Datasheet, PDF (84/120 Pages) Mitsubishi Electric Semiconductor – SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER

MITSUBISHI MICROCOMPUTERS
M37212M4/M8–XXXSP, M37212M6–XXXSP/FP
M37212EFSP/FP
SINGLE-CHIP 8-BIT CMOS MICROCOMPUTER for VOLTAGE SYNTHESIZER
with ON-SCREEN DISPLAY CONTROLLER
GZZ–SH55–23B < 91A0 >
740 FAMILY MASK ROM CONFIRMATION FORM
SINGLE-CHIP MICROCOMPUTER M37212M4-XXXSP
MITSUBISHI ELECTRIC
(2) Write the ASCII codes that indicate the product name of “M37212M4–” to addresses 000016 to 000F16.
Note:
Addresses 000016 to 000F16 store the product name. _Address
ASCII codes ‘M37212M4-’ are listed on the right.
The addresses and data are in hexadecimal notation.
000016
000116
000216
000316
If the name of the product contained in the EPROMs does
000416
not match the name on the mask ROM confirmation form,
000516
the ROM processing is disabled. Please make sure the
000616
data is written correctly.
000716
‘M’ =
‘3’ =
‘7’ =
‘2’ =
‘1’ =
‘2’ =
‘M’ =
‘4’ =
4D16
3316
3716
3216
3116
3216
4D16
3416
Address
000816
000916
000A16
000B16
000C16
000D16
000E16
000F16
‘–’ =
2D16
FF16
FF16
FF16
FF16
FF16
FF16
FF16
Ordering by floppy disk
We will produce masks based on the mask files generated by the mask file generating utility. We shall assume the
responsibility for errors only if the mask ROM data on the products we produce differs from this mask file. Thus, extreme
care must be taken to verify the mask file in the submitted floppy disk.
The submitted floppy disk must be 3.5-inch 2HD type and DOS/V format. And the number of the mask files must be 1 in
one floppy disk.
File code
(hexadecimal notation)
Mask file name
.MSK (equal or less than eight characters)
V2. Mark specification
Mark specification must be submitted using the correct form for the type of package being ordered. Fill the appropriate
mark specification form (52P4B for M37212M4-XXXSP) and attach to the mask ROM confirmation form.
V3. Comments
(2/3)
Rev. 1.0
83