R1EX24008ASAS0G Datasheet, PDF (8/18 Pages) Renesas Technology Corp – Two-wire serial interface 8k EEPROM

R1EX24008ASAS0G/R1EX24008ATAS0G
Preliminary
Device Addressing
The EEPROM device requires an 8-bit device address word following a start condition to enable the chip for a read or a
write operation. The device address word consists of 4-bit device code, 3-bit device address code and 1-bit
read/write(R/W) code. The most significant 4-bit of the device address word are used to distinguish device type and this
EEPROM uses “1010” fixed code. The device address word is followed by the 1-bit device address code A2, memory
address a9, a8. The device address code selects one device out of two devices which are connected to the bus. This
means that the device is selected if the inputted 1-bit device address code is equal to the corresponding hard-wired A2
pin status. The eighth bit of the device address word is the read/write(R/W) bit. A write operation is initiated if this bit
is “0” and a read operation is initiated if this bit is “1”. The EEPROM turns to a stand-by state if the device code is not
“1010” or device address code doesn’t coincide with status of the correspond hard-wired device address pins A0 to A2.
Device Address Word
Device address word (8-bit)
Device code (fixed)
Device address code
8k
1
0
1
0
A2
a9
a8
Note: 1. R/W=“1” is read and R/W = “0” is write.
R/W code*¹
R/W
R10DS0080EJ0100 Rev.1.00
Mar. 07, 2013
Page 8 of 16