HD74ALVCH162830 Datasheet, PDF (4/11 Pages) Hitachi Semiconductor – 1-bit to 2-bit Address Driver with 3-state Outputs

HD74ALVCH162830
Absolute Maximum Ratings
Item
Symbol
Ratings
Unit Conditions
Supply voltage
Input voltage ^*1
Output voltage ^{*1, 2}
Input clamp current
Output clamp current
Continuous output current
V_CC, GND current / pin
Maximum power dissipation
at Ta = 55°C (in still air) ^*3
V_CC
V_I
V_O
I_IK
I_OK
I_O
I_CC or I_GND
P_T
–0.5 to 4.6
–0.5 to 4.6
–0.5 to V_CC +0.5
–50
±50
±50
±100
1
V
V
V
mA
V_I < 0
mA
V_O < 0 or V_O > V_CC
mA
V_O = 0 to V_CC
mA
W
TVSOP
Storage temperature
T_stg
–65 to 150
°C
Notes: Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to
the device. These are stress ratings only, and functional operation of the device at these or any
other conditions beyond those indicated under “recommended operating conditions” is not implied.
Exposure to absolute maximum rated conditions for extended periods may affect device reliability.
1. The input and output negative voltage ratings may be exceeded if the input and output clamp
current ratings are observed.
2. This value is limited to 4.6 V maximum.
3. The maximum package power dissipation is calculated using a junction temperature of 150°C
and a board trace length of 750 mils.
Recommended Operating Conditions
Item
Symbol
Min
Max
Unit Conditions
Supply voltage
V_CC
Input voltage
V_I
Output voltage
V_O
High level output current
I_OH
2.3
3.6
V
0
V_CC
V
0
V_CC
V
—
–6
mA
V_CC = 2.3 V
—
—
Low level output current
I_OL
—
—
—
Input transition rise or fall rate ∆t / ∆v
0
–8
V_CC = 2.7 V
–12
V_CC = 3.0 V
6
mA
V_CC = 2.3 V
8
V_CC = 2.7 V
12
V_CC = 3.0 V
10
ns / V
Operating temperature
T_a
–40
85
°C
Note: Unused control inputs must be held high or low to prevent them from floating.
Rev.2.00, Oct.02.2003, page 4 of 10