R0E5563NEDMB01 Datasheet, PDF (3/8 Pages) Renesas Technology Corp – 100-pin 0.5mm-pitch LQFP

R0E5563NEDMB01
User's Manual
3. Specifications
Table 2 shows the functional specifications of this product.
Table 2
Item No.
1
2
3
4
5
Specifications of This Product
Item
Specification
MCU for use
•RX63N- and RX631-group MCUs in PLQP0100KB-A packages
The MCU type name
installed on this product
•R5F563NEDDFC
(ROM: 2 Mbytes, RAM: 128 Kbytes, E2 Data Flash: 32 Kbytes )
Power supply
•Power (VCC = AVCC0 = VREFH = VCC_USB) at 2.7^*1 to 3.6 V is supplied
from the user system.
•Power (VREFH0) at 2.7 to AVCC0 is supplied from the user system.
•Power (VBATT) at 2.3 to 3.6 V is supplied from the user system.
•The state of power supply can be monitored through the test pins (TP1 for
VREFH0, TP2 for AVCC0, TP3 for VREFH, TP4 for VBATT, TP5 for
VCC_USB, TP6 for VCC, and TP7 for GND).
System clock (EXTAL) •4 to 16 MHz clock signals are supplied from the user system.
Sub clock (XCIN)
•32.768 kHz clock signals are supplied from the user system.
Note*: 1. Use this product at a voltage (VCC > V_POR) that doesn't make the MCU enter the state of power on reset.
4. Reset Circuit
Figure 2 shows the reset circuit, with the level on the RES# pin pulled up by a 510-kΩ resistor.
38-pin connector (CN3)
R0E5563NEVKZ00
UVCC
MCU (IC1)
R0E55630EPFK20
YQSOCKET100SDF (IC1)
R8
510kΩ
R9
RES#
0Ω
Pin 10 (RES#)^*2
Pin 9 (RES#)^*1
Notes*: 1. The number indicated is the pin number of the 38-pin connector (CN3).
2. The number indicated is the pin number of the YQSOCKET100SDF (IC1).
Figure 2 Reset Circuit
R20UT2221EJ0200 Rev.2.00
Mar 05, 2014
Page 3 of 8