M35049-XXXFP Datasheet, PDF (12/39 Pages) Renesas Technology Corp – SCREEN CHARACTER and PATTERN DISPLAY CONTROLLERS

MITSUBISHI MICROCOMPUTERS
M35049-XXXFP
SCREEN CHARACTER and PATTERN DISPLAY CONTROLLERS
(4) Address 12316
DA Register
0
VP0
1
VP1
Contents
Status
Function
0 If VS is the vertical display start location,
7
1 VS = H × Σ 2nVPn
n=0
0 _{H: Cycle with the horizontal synchronizing pulse}
1 _{255 settings are possible.}
0
2
VP2
1
HOR
Remarks
The vertical start location is specified
using the 10 bits from VP7 to VP0.
VP7 to VP0 = (00000000002) setting is
forbidden.
0
3
VP3
1
0
4
VP4
1
0
5
VP5
1
0
6
VP6
1
VS
HS*
Display area
HS* (shown left) shows horizontal
__
display start location that is register B/F
(address 12816) = 0 is set.
0
7
VP7
1
0 It should be fixed to “0”.
8
TEST32
1 Can not be used.
0 It should be fixed to “0”.
9
TEST33
1 Can not be used.
0 It should be fixed to “0”.
A
TEST0
1 Can not be used.
0 It should be fixed to “0”.
B
TEST1
1 Can not be used.
0 It should be fixed to “0”.
C
TEST2
1 Can not be used.
0 It should be fixed to “0”.
D
TEST3
1 _{Can not be used.}
0 _{It should be fixed to “0”.}
E
TEST34
(Note 3)
1 _{Can not be used.}
____
Notes 1. The mark around the status value means the reset status by the "L" level is input to AC pin.
2. The page in which data is written is controlled by the DAF bit. When set to "0", data is written into page 0, whereas when set to "1", data is written
into page 1.
3. Registers marked with (Note 3) are found only in page 0, therefore the register value does not change when the DAF bit is set to "1".
11