|
PS2801C-1-P-A Datasheet, PDF (10/13 Pages) Renesas Technology Corp – HIGH ISOLATION VOLTAGE SSOP PHOTOCOUPLER | |||
|
◁ |
PS2801C-1, PS2801C-4e
A Business Partner of Renesas Electronics Corporation.
<R> NOTES ON HANDLING
1. Recommended soldering conditions
(1) Infrared reflow soldering
⢠Peak reflow temperature
⢠Time of peak reflow temperature
⢠Time of temperature higher than 220°C
⢠Time to preheat temperature from 120 to 180°C
⢠Number of reflows
⢠Flux
260°C or below (package surface temperature)
10 seconds or less
60 seconds or less
120±30 s
Three
Rosin flux containing small amount of chlorine (The
flux with a maximum chlorine content of 0.2 Wt% is
recommended.)
Recommended Temperature Profile of Infrared Reflow
180°C
120°C
120±30 s
(preheating)
(heating)
to 10 s
to 60 s
260°C MAX.
220°C
Time (s)
(2) Wave soldering
⢠Temperature
⢠Time
⢠Preheating conditions
⢠Number of times
⢠Flux
260°C or below (molten solder temperature)
10 seconds or less
120°C or below (package surface temperature)
One (Allowed to be dipped in solder including plastic
mold portion.)
Rosin flux containing small amount of chlorine (The flux
with a maximum chlorine content of 0.2 Wt% is
recommended.)
(3) Soldering by Soldering Iron
⢠Peak Temperature (lead part temperature)
⢠Time (each pins)
⢠Flux
350°C or below
3 seconds or less
Rosin flux containing small amount of chlorine (The flux
with a maximum chlorine content of 0.2 Wt% is
recommended.)
(a) Soldering of leads should be made at the point 1.5 to 2.0 mm from the root of the lead
(4) Cautions
⢠Fluxes
Avoid removing the residual flux with freon-based and chlorine-based cleaning solvent.
R08DS0072EJ0400 Rev.4.00
Jan 9, 2013
Page 10 of 12
|
▷ |