PS2702-1_15 Datasheet, PDF (10/15 Pages) Renesas Technology Corp – HIGH ISOLATION VOLTAGE DARLINGTON TRANSISTOR

PS2702-1
NOTES ON HANDLING
1. Recommended soldering conditions
(1) Infrared reflow soldering
• Peak reflow temperature
• Time of peak reflow temperature
• Time of temperature higher than 220°C
• Time to preheat temperature from 120 to 180°C
• Number of reflows
• Flux
260°C or below (package surface temperature)
10 seconds or less
60 seconds or less
120±30 s
Three
Rosin flux containing small amount of chlorine (The
flux with a maximum chlorine content of 0.2 Wt% is
recommended.)
Recommended Temperature Profile of Infrared Reflow
180˚C
120˚C
120±30 s
(preheating)
(heating)
to 10 s
to 60 s
260˚C MAX.
220˚C
Time (s)
(2) Wave soldering
• Temperature
• Time
• Preheating conditions
• Number of times
• Flux
260°C or below (molten solder temperature)
10 seconds or less
120°C or below (package surface temperature)
One (Allowed to be dipped in solder including plastic
mold portion.)
Rosin flux containing small amount of chlorine (The flux
with a maximum chlorine content of 0.2 Wt% is
recommended.)
(3) Soldering by Soldering Iron
• Peak Temperature (lead part temperature)
• Time (each pins)
• Flux
350°C or below
3 seconds or less
Rosin flux containing small amount of chlorine (The flux
with a maximum chlorine content of 0.2 Wt% is
recommended.)
(a) Soldering of leads should be made at the point 1.5 to 2.0 mm from the root of the lead
<R>
(4) Cautions
• Fluxes
Avoid removing the residual flux with freon-based and chlorine-based cleaning solvent.
R08DS0099EJ0300 Rev.3.00
Jan 29, 2013
Page 10 of 13