HN58X2532I Datasheet, PDF (10/22 Pages) Renesas Technology Corp – Serial Peripheral Interface Electrically Erasable and Programmable Read Only Memory

HN58X2532I/HN58X2564I
Write Enable (WREN):
The Write Enable Latch (WEL) bit must be set prior to each WRITE and WRSR instruction. The only way to do this is
to send a Write Enable instruction to the device. As shown in the following figure, to send this instruction to the
device, chip select (S) is driven low, and the bits of the instruction byte are shifted in, on serial data input (D). The
device then enters a wait state. It waits for the device to be deselected, by chip select (S) being driven high.
Write Enable (WREN) Sequence
V_IH
S
V_IL
V_IH
W
V_IL
V_IH
C
V_IL
V_IH
D
V_IL
0 123 456 7
Instruction
Q
High-Z
Rev.3.00, Jul.06.2005, page 10 of 20