G3HSPA00 Datasheet, PDF (1/4 Pages) Red Lion Controls. Inc – MODEL G3HSPA - G3 SERIES HSPA+ CELLULAR MODEM OPTION CARD FOR G3 OPERATOR INTERFACE TERMINALS

Tel [phone]
Fax [phone]
www.redlion.net
Bulletin No. G3HSPA-B
Drawing No. LP0965
Released 04/15
MODEL G3HSPA - G3 SERIES HSPA+ CELLULAR MODEM
OPTION CARD FOR G3 OPERATOR INTERFACE TERMINALS
CONNECTOR
(SIDE 2)
zz CONFIGURED USING CRIMSON SOFTWARE (VERSION 3.0 OR
LATER)
zz SUPPORTS HSPA+ CELLULAR DATA CONNECTIVITY WITH FALL
BACK TO 3G AND 2G
zz UP TO 21 MBPS DOWNLINK/5.76 MBPS UPLINK SPEEDS
zz INSTALLS INSIDE A G3 OPERATOR INTERFACE TERMINAL
zz INSTALLATION AND CONNECTION HARDWARE INCLUDED
WITH CARD
MOUNTING HOLES
(3 PLACES)
POWER
LED
ANTENNA
GENERAL DESCRIPTION
The G3HSPA option card allows the user to add HSPA+ cellular modem
capability to their G3 operator interface terminal. The cellular standard adopted
in this option card is HSPA+ with fallback capability to 3G and 2G. It can get
speeds up to 21 Mbps downlink and 5.76 Mbps uplink. It’s built upon the GSM
standard, offered in the US and widely available throughout the world. HSPA+
can be used for services such as Wireless Application Protocol (WAP) access,
Short Message Service (SMS), and for Internet connectivity.
The G3HSPA option card is penta-band, allowing it to work in frequencies
across the Americas, Europe and Asia. US and Canada work in the 850/1900
MHz bands, while Europe, Middle East, Africa and most of Asia work in the
900/1700/2100 MHz HSPA+ frequencies.
The G3HSPA requires the addition of a SIM (Subscriber Identity Module)
card, which is inserted into the holder prior to installation of the G3HSPA card.
The SIM card securely stores the service-subscriber key (IMSI) used to identify
a subscriber, and is used to connect to the network to obtain an IP address from
the provider.
SAFETY SUMMARY
All safety related regulations, local codes and instructions that appear in the
manual or on equipment must be observed to ensure personal safety and to
prevent damage to either the instrument or equipment connected to it. If
equipment is used in a manner not specified by the manufacturer, the protection
provided by the equipment may be impaired.
Do not use the module to directly command motors, valves, or other actuators
not equipped with safeguards. To do so can be potentially harmful to persons or
equipment in the event of a fault to the module.
CAUTION: Risk of Danger.
Read complete instructions prior to
installation and operation of the unit.
CONTENTS OF PACKAGE
- G3HSPA Option card
- Cable already attached to G3HSPA option card
- Hardware pack consisting of three screws.
- This hardware bulletin
ORDERING INFORMATION
MODEL NO. DESCRIPTION
G3HSPA
GSM/HSPA+ Modem Option Card for G3
operator interface ¹
2G/3G 3" hinged antenna
ANT
2G/3G/4G LTE low profile direct permanent
mount antenna, IP67 rated
2G/3G 4.5" whip magnetic mount antenna,
IP65 rated
2G/3G low profile direct permanent mount
antenna, IP65 rated
PART NUMBER
G3HSPA00
ANT-TG090113
ANT-G30B108111
ANT-GA107201111
ANT-G21B301111
1 _{Antenna is NOT included with the card. Must be purchased separately if}
needed.
SPECIFICATIONS
1. POWER REQUIREMENTS:
24VDC ± 20%; (independent from the host G3 power connection). Must use
NEC Class 2 or Limited Power Source (LPS) rated power supply.
G3HSPA Max Power:
HSPA+ Mode: During continuous active webserver traffic
Instantaneous maximum: 5.5 W
Average:
3.7 W
GPRS Mode:
Instantaneous maximum: 14.5 W (1.1 msec every 4.6 msec)
Average:
7.0 W
2. LINK STATUS LEDs:
Link Status - Link Status LED shows cellular link condition.
1