RPA120H-RW Datasheet, PDF (1/7 Pages) Recom International Power – UL, IEC/EN60950-1 & EN50155 Pending

Features
Regulated
Converters
• 4:1 Wide Input Voltage Range
• 3kVDC Isolation and Reinforced Insulation
• UL, IEC/EN60950-1 & EN50155 Pending
• Efficiency up to 88.5%
• OCP, OVP, OTP
• +100°C max. Case Temperature
DC/DC Converter
RPA120H-RW
Description
The RPA120H series are high power, 110VDC wide input range 120W DC/DC converters in an
industry standard half brick format. Despite their low cost, the RPA120H converters are fully specified
devices with output currents up to 8.3Amps, up to 88.5% efficiency, no minimum load,
3kVDC isolation, tight regulation and low ripple/noise figures. The trimmable outputs are also fully
protected against over-temperature, short circuits, overcurrent and overvoltage. The converters are
UL and EN50155 pending and will find many uses in cost sensitive railway and industrial applications.
120 Watt
Half Brick
5^{5 YEAR}
warranty
Single Output
Selection Guide
Part Number
Input
Voltage Range
[VDC]
RPA120H-11012SRW⁽²⁾ 53-154
RPA120H-11015SRW⁽²⁾ 53-154
RPA120H-11024SRW⁽²⁾ 53-154
Output
Voltage
[VDC]
12
15
24
Output
Current
[mA]
8300
6700
5000
Output
Power
[W]
100
100
120
Efficiency⁽¹⁾
typ.
[%]
86
88.5
88.5
Max. Capacitive
Load
[µF]
680
680
300
Notes:
Note1: Efficiency is tested by nominal Vin, full load and at 25°C.
Model Numbering
RPA120H-__ __ SRW/_ _
Input Voltage
Output Voltage
Single
CTRL Logic⁽²⁾
Gate Out Pin⁽²⁾
Ordering Examples
RPA120H-11012SRW/P = 110V Input, 12V Output, Single, Pos. CTRL function, without Gate Out pin
RPA120H-11015SRW/GP = 110V Input, 15V Output, Single, Pos. CTRL function, with Gate Out pin
RPA120H-11024SRW/N = 110V Input, 24V Output, Single, Neg. CTRL function, without Gate Out pin
RPA120H-11015SRW/GN = 110V Input, 15V Output, Single, Neg. CTRL function, with Gate Out pin
E224736
UL60950-1 Pending
IEC/EN60950-1 Pending
EN50155 Pending
Notes:
Note2: standard part is with suffix “P” for positive logic (1=ON, 0=OFF) omitted Gate Out pin

or add suffix “N” instead for negative logic (0=ON, 1=OFF) omitted Gate Out pin

add suffix “G” for Gate Out pin
www.recom-power.com
REV.: 0/2016
PB-1