RACV04 Datasheet, PDF (1/4 Pages) Recom International Power – low Standby Power, ErP conform

Features
LED
Driver
• 4W AC-DC Class II LED Power Supply
• 12V and 24V Constant Voltage Output
• Fully Protected (OLP, SCP, OCP, OTP)
• low Standby Power, ErP conform
• IP65 (suitable for dry and damp locations)
• low cost
• CE, CB, ENEC, CSA and UL8750 certified.
• Wired connections for independent or built-in use
AC/DC Converter
RACV04
Description
These constant voltage LED drivers have been designed for cost-sensitive applications. The SELV
outputs are suitable for built-in power-supply LED luminaires. Their low profile design allows them
to be invisibly built into furniture, discreetly mounted under shelves or integrated in space-restricted
applications such as coving lighting, strip lighting or troffer lighting systems. The power supplies are
short circuit and overload protected and come with a full 3-year warranty.
Selection Guide
Part
Number
nom. Input
Voltage
[VAC]
RACV04-12
115/230
RACV04-24
115/230
Input
Current
[mA]
100
100
Output
Voltage
[VDC]
12
24
Output
Current Range
[mA]
0-330
0-170
Efficiency Output
typ. Power max.
[%]
[W]
75
4
75
4
All LED Drivers may not be used without a load. They must be switched on the primary side only.
Noncompliance may damage the LED or reduce its lifetime.
4 Watt
Constant
3^{3 YEAR}
warranty
Voltage Single
Output
Specifications (measured @ ta= 25°C, 240VAC and rated load)
BASIC CHARACTERISTICS
Parameter
Condition
Min.
Typ.
Input Voltage Range
90VAC
230VAC
Inrush Current
Start-up Time
Input Frequency Range
47Hz
No Load Power Consumption
Power Factor
full load, 230VAC
Internal Operating Frequency
full load
64kHz
Output Ripple Voltage ⁽¹⁾
12VDC
24VDC
Notes:
Note1: Measured at 20MHz BW using 0.1µF & 47µF parallel capacitor.
Max.
264VAC
11A
500ms
63Hz
0.5W
0.40
120mVp-p
240mVp-p
ERP
compliant
REGULATIONS
Parameter
Output Voltage Accuracy
Line Regulation
Load Regulation
PROTECTION
Parameter
Input Fuse
Open Circuit Protection (OCP)
Over Load Protection (OLP)
Over Voltage Protection (OVP)
www.recom-power.com
Condition
Value
±5% max.
5% max.
5% max.
UL8750 Certified
CSA C22.2 No. 250.13 Certified
IEC62384 Certified
EN55015 Compliant
CB Report
Condition
Value
external fuse is recommended
0.22W fusible resistor
auto recovery after fault condition is removed
auto recovery after fault condition is removed
auto recovery after fault condition is removed
continued on next page
REV.: 0/2016
L-1