RACD60_1104 Datasheet, PDF (1/4 Pages) Recom International Power – 60 Watt PFC Single Output

Features
LED DRIVER
● 60W Class II AC-DC LED Power Supply
● Dual Mode CV or CC Output
● Power Factor Corrected
● Universal Input Voltage Range
● User Adjustable Current Limit (/OF)
● Thermal Feedback Dimming (/TOF)
● Waterproof Enclosure (/IP67)
● cUL/UL8750 Certified, CE Marked
● High Efficiency
● Long 5 Year Warranty
LIGHTLINE
AC/DC-Converter
with 5 year Warranty
60 Watt PFC
Selection Guide
Single Output
Part
Number
RACD60-4200*
Output
Voltage Range
(min - max)
11 - 13.5V
Output
Current Range
(min - max)
3570 - 4200mA
Factory Set
Current
Limit
4.2A
Efficiency
(230VAC)
Typ.
85%
Output
Power
Range
40-60W
RACD60-2400*
17 - 24V
2150 - 2500mA
2.4A
87% 30-60W
RACD60-2100*
21 - 28V
1400 - 2140mA
2.1A
89% 30-60W
RACD60-1400*
21 - 28V
1400 - 2140mA
1.4A
89% 30-60W
RACD60-1050*
38 - 54V
700 - 1100mA
1.0A
89% 27-60W
RACD60-700*
38 - 54V
700 - 1100mA
0.7A
89% 27-60W
* use suffix /OF for open frame version (standard) - output current limit adjustable with on-board trimmer
* use suffix /TOF for open frame version with thermal feedback - output current limit externally adjustable.
* use suffix /IP67 for waterproof potted version - fixed output currents only
ordering examples:
RACD60-700/OF= open frame, adustable current limit preset to 700mA.
RACD60-1050/TOF=open frame,1050mA, adjustable 700-1050mA with ext. voltage or PWM signal.
RACD60-1400/IP67 = enclosed IP67 waterproof, non-adjustable 1400mA output.
Note: all currents within range are available - use RACD60-xxxx/IP67 where xxxx is the desired fixed current
e.g. RACD60-900/IP67 = enclosed IP67 waterproof, non-adjustable 900mA output.
Specifications (typical at 25°C and after warm up time unless otherwise specified )
E340696
RoHS
2002/95/EC
6/6
UL 8750 Certified
cUL 8750 Certified*
EN 61347 Certified
Input Voltage Range
Rated Power
Input Frequency Range
Power Factor Correction
Input Current (full load)
Inrush Current (cold start)
Leakage Current
Input Fuse
Output Current Accuracy
Output Current Adjust
Line Voltage Regulation
Load Voltage Regulation
Minimum Load Current
Output Ripple and Noise
Operating Frequency
Efficiency at Full Load
Isolation Voltage (60Hz RMS)
Temperature Coefficient
Overload Protection
Short Circuit Protection
All Versions
90-264VAC
60 Watts max.
All Versions
50/60 Hz
Full Load, 115VAC/230VAC
> 0.9
115VAC/230VAC
0.8A / 0.4A max.
115VAC/230VAC
25A / 50A max.
230VAC/63Hz
<0.7mA max.
Built-in
3.15A Slow Blow
Full load
Preset Potentiometer (/OF)
External Voltage (/TOF)
±5%
75% to 100% approx.
LL to HL at Full Load
±4% typ.
60% to 100% Load
±5% typ.
see table
20MHz limited,with 0.1µF + 47µF
5Vp-p max.
All Versions
65kHz typ.
input to output
input to filter ground
output to filter ground
see table
3.75kVAC / 1 minute
1880VAC / 1 minute
500VAC / 1 minute
All Versions
±0.02%/°C typ.
All Versions
105% typ.
Continuous, Hiccup, Automatic Restart
RACD60
* except 700mA/1100mA Versions
Description
The RACD60 is a compact universal input voltage
60W constant constant current power module
suitable for driving high power LEDs. The LED
driver has a dual mode of operation:-
CV mode: at loads below the preset current limit,
the RACD60 behaves as a fixed voltage source.
CC mode: at loads above the preset current limit,
the RACD60 behaves as a fixed current source.
Thus the same power supply can be used with
both CV and CC LED modules.
The RACD60 series have a universal input voltage
range with active power factor correction and are
fully protected against output short circuit, over-
load and over-temperature.
Three versions are available: a low cost open-
frame with either internal (/OF) or external user-
adjustable current limit (/TOF), and a sealed IP67
potted version (/IP67) with factory set output
currents for outdoor or high humidity applications.
Please Read Application Notes
26
REV: 4/2011
www.recom-electronic.com