RACD35-A Datasheet, PDF (1/2 Pages) Recom International Power – 35 Watt PFC Single Output

Features
LED DRIVER
● 35W Class II AC-DC LED Power Supply
● 500, 700, 1000, 1400mA or 2500mA Output
● Active Power Factor Correction >0.90
● Efficiency up to 83%
● IP67 Certified
● 3 in 1 Dimming
Description
The 35W LED drivers of the RACD35-A series come with a 3-in-1 dimming function so that the LED load can
be dimmed with analog (1-10V), PWM, or resistor inputs. Due to wide input voltage range of 90 - 305VAC
these LED drivers are suitable for worldwide use. They operate with efficiencies of up to 83%, feature active
PFC, and are fully protected against short circuit, overvoltage, and over-temperature conditions.
They are sealed against damp and wet conditions, and the warranty is 5 years.
Selection Guide
Part
Number
RACD35-500A
Rated
Power
(W)
28.5
Output
Current
(mA)
500
Output
Voltage
(VDC)
48 - 57
Efficiency
(typ.)
(%)
82
RACD35-700A
33,6
700
33 - 48
79
RACD35-1000A
36
1000
24 - 36
82
RACD35-1400A
33.6
1400
12 - 24
81
RACD35-2500A
30
2500
9 - 12
80
Specifications (measured at 240VAC and 25°C ambient temperature)
Input Voltage Range
90-305 VAC
Input Frequency Range
47-63Hz
Power Factor
Full Load, 277VAC
>0.90
Full Load, 230VAC
>0.95
Full Load, 110VAC
>0.98
AC Input Current
110VAC
0.5A
230VAC
0.3A
Inrush Current (Max.)
264VAC
Cold Start 60A
Leakage Current
230VAC
<0.25mA
Output Current Accuracy (includes Line Regulation, Load Regulation and set-up tolerance)
±5%
Isolation Voltage
3.75kVAC / 1minute
Short Circuit Protection
Hiccup mode & recovers after fault condition removed
Over Voltage Protection
115% - 135% Output Voltage
Latch Mode
Over Temperature Protection
Thermistor
105°C ± 10°C
Type
Latch Mode
Dimming Control:
PWM
1<Adj<10V(500Hz - 3kHz)
Analogue
control by external voltage 1-10VDC
Resistance
10K - 100KΩ
Set Up Time
Full Load, 230VAC
2 sec
Storage Humidity
10% - 95% RH
Operating Humidity
20% - 95% RH Non-Condensing
Weight
384g
Dimension (LxBxH)
110 x 73.5 x 33mm
Operating Temperature Range
Full load
-20°C to +50°C
(free air convection - 10LFM)
Case Temperature
85°C ± 10°C
Storage Temperature
-40°C to +80°C
IP Rating
IP67
Isolation Resistance
500VDC
100MΩ
MTBF (+25°C)
using MIL-HDBK 217F
200 x 10³ hours
Certifications:
UL Standards
Report: E340696
UL8750, (based on) UL1310
Safety Standards
Report: P201403013
EN61347-1; EN61347-2-13
continued on next page
L-46
REV: 0/2015
LIGHTLINE
AC/DC-Converter
with 5 year Warranty
35 Watt PFC
Single
Output
RoHS
2011/65/EU
6/6 _E340696
UL8750 Certified
EN61347 Certified
EN55015 Certified
EN61547 Certified
RACD35-A
Derating-Graph
(Ambient Temperature)
Load
100%
80%
60%
40%
20%
AC 100V - 295V
Horizontal
-20 0 20 50
Ambient Temperature (°C)
Note:
All LED Drivers may not be used without a
load. They must be switched on the primary
side only. Noncompliance may damage the
LED or reduce its lifetime.
Refer to Application Notes
www.recom-power.com