RACD04 Datasheet, PDF (1/4 Pages) Recom International Power – low Standby Power, ErP conform

Features
LED
Driver
• 4W AC-DC Class II LED Power Supply
• 350mA to 700mA Constant Current Outputs
• Fully Protected (OLP, SCP, OCP, OTP)
• low Standby Power, ErP conform
• IP65 (suitable for dry and damp locations)
• low cost
• CE, CB, ENEC, CSA and UL8750 certified.
• Wired connections for independent or built-in use
AC/DC Converter
RACD04
Description
These constant current LED drivers have been designed for cost-sensitive applications. The SELV
outputs are suitable for built-in power-supply LED luminaires. Their low profile design allows them
to be invisibly built into furniture, discreetly mounted under shelves or integrated in space-restricted
applications such as coving lighting, strip lighting or troffer lighting systems. The power supplies are
short circuit and overload protected and come with a full 3-year warranty.
Selection Guide
Part
Number
nom. Input
Voltage
[VAC]
Input
Current
[mA]
Output
Voltage Range
[VDC]
Output Efficiency Output
Current
typ. Power max.
[mA]
[%]
[W]
RACD04-350
115/230
100
3-12
350
77
4.2
RACD04-500
115/230
100
3-8
500
75
4
RACD04-700
115/230
100
3-6
700
72
4.2
All LED Drivers may not be used without a load. They must be switched on the primary side only.
Noncompliance may damage the LED or reduce its lifetime.
4 Watt
Constant
3^{3 YEAR}
warranty
Current Single
Output
Specifications (measured @ ta= 25°C, 240VAC and rated load)
BASIC CHARACTERISTICS
Parameter
Condition
Min.
Typ.
Input Voltage Range
90VAC
230VAC
Inrush Current
Open Circuit Voltage
Start-up Time
350mA
500mA
700mA
Input Frequency Range
47Hz
No Load Power Consumption
Power Factor
full load, 230VAC
Internal Operating Frequency
full load
64kHz
Output Ripple Current ⁽¹⁾
Notes:
Note1:
350mA
500mA; 700mA
Measured at 20MHz BW using 0.1µF & 47µF parallel capacitor.
Max.
264VAC
10A
16VDC
12VDC
9VDC
500ms
63Hz
0.5W
0.40
80mAp-p
90mAp-p
ERP
compliant
REGULATIONS
Parameter
Output Current Accuracy
Line Regulation
Load Regulation
Condition
Value
±5% max.
5% max.
5% max.
UL8750 Certified
CSA C22.2 No. 250.13 Certified
IEC62384 Certified
EN55015 Compliant
CB Report
PROTECTION
Parameter
Input Overcurrent Protection
Open Circuit Protection (OCP)
Condition
Value
internal
0.22W fusible resistor
auto recovery after fault condition is removed
continued on next page
www.recom-power.com
REV.: 0/2016
L-1