SMN2010A-1R00-J Datasheet, PDF (1/1 Pages) RCD COMPONENTS INC. – THICK FILM CONVEX CHIP ARRAYS

THICK FILM CONVEX CHIP ARRAYS
SMN SERIES Resistor Arrays
Term.W is
RoHS
ZMN SERIES ^compliant
Jumper Arrays ^RoHS
& 260°C
compatible
RESISTORS CAPACITORS COILS DELAY LINES
Internationally popular convex termination pads
Industry’s widest selection and lowest cost!
1Ω to 10MΩ, 0.5% to 5%, 8 sizes, 3 circuit schematics
2 to 9 resistors per array reduces mounting costs
ZMN Series zero ohm jumpers are 1Amp, 50mΩ max
Scalloped edge design available
RCD’s Series SMN resistor and ZMN jumper chip arrays not
only enable significant pcb space savings, but a sizeable cost
savings over the use of individual components. The savings in
assembly cost, by placing a single chip instead of multiple chips,
more than pays for the cost of these components. SMN/ZMN
feature convex terminations, concave avaliable (see CN Series).
4 PIN: SMN0404, SMN0606
→P ←
↑
W
--- ↓ T
↑
↓
---
←_L→ → H ←
1
Config. A
8 PIN: SMN0804, SMN1206, SMN2012
↑
↓
---
T
↑
W
→_P←
L
↓
---
→ H←
1 _{Config. A} 1 _{Config. B}
10 PIN: SMN2010, SMNN1206 (SMNN1206 avial. in Config. D only)
↓
↑
--- T
↑
W
→_P←
L
↓
---
→H←
1
1
1
Config. A Config. B Config. D
16 PIN: SMN1506
↑
L
W
↓
--- T
↑
→
P
←
L
↓
---
→ H←
1
Config. A
RCD Type Config Rated Working
TC
Res.Range Res.Range Res.Range
Power* Voltage (ppm/°C) 0.5% Tol 1% Tol 2 & 5% Tol
SMN0404
A
62mW
25V
SMN0606
A
62mW
50V
SMN0804
A
62mW
25V
SMN1206
A
62mW
50V
SMNN1206
D
31mW
25V
SMN1506
A
62mW*** 25V
SMN2010
A
100mW
50V
SMN2010
B
55mW
50V
SMN2012
A
125mW
50V
SMN2012 B**
62mW
50V
250ppm
200ppm
250ppm
200ppm
200ppm
200ppm
200ppm
200ppm
200ppm
200ppm
**
**
**
22Ω-470K
**
**
**
**
**
**
**
**
**
1Ω - 10M
**
**
**
**
22Ω - 1M
**
10Ω - 1M
1Ω - 10M
10Ω - 1M
1Ω - 10M
10Ω - 1M
10Ω - 1M
10Ω - 1M
10Ω - 1M
10Ω - 1M
10Ω - 1M
* Rated power is per resistor element at 70°C ** Consult factory for availability *** SMN1506 package power rating is .25W
L ±.01
[.25]
.039 [1]
.063 [1.6]
.079 [2]
.126 [3.2]
.126 [3.2]
.154 [3.9]
.200 [5.08]
.200 [5.08]
.200 [5.08]
.200 [5.08]
W±.008
[.2]
.039 [1]
.063 [1.6]
.039 [1]
.063 [1.6]
.063 [1.6]
.063 [1.6]
.100 [2.54]
.100 [2.54]
.122 [3.10]
.122 [3.10]
P±.008
[.2]
.025 [.65]
.0315 [.8]
.02 [.5]
.0315 [.8]
.025 [.64]
.02 [.5]
.040 [1.0]
.040 [1.0]
.050 [1.27]
.050 [1.27]
H±.006
[.15]
.016 [.4]
.022 [.55]
.016 [.4]
.022 [.55]
.022 [.55]
.018 [.45]
.024 [.6]
.024 [.6]
.024[ .6]
.024 [.6]
T typ.
.010 [.25]
.012 [.3]
.010 [.25]
.010 [.25]
.010 [.25]
.012 [.3]
.010 [.25]
.010 [.25]
.012 [.30]
.012 [.30]
DERATING
100
75
50
25
0
25 50
75 100 125 150 175 200
70 AMBIENT TEMPERATURE (°C)
SUG_1111122222G₃₃₃₃₃EST_1111122222ED P_1111122222A₃₃₃₃₃D ₁₁₁₁₁L₂₂₂₂₂A₃₃₃₃₃YO_1111122222U₃₃₃₃₃T
D
C
↑
↓
↑
↓
111112222233333
1111122222
111112222233333 _{111112222233333} 111112222233333
→ A ← → B←
RCD Type
A
B
C
D
SMN0404 (4-pin) .014 [.36] .011 [.28] .020 [.5] .020 [.5]
SMN0606 (4-pin) .016 [.4] .016 [.4] .032 [.8] .036 [.9]
SMN0804 (8-pin) .012 [.3] .008 [.2] .020 [.5] .020 [.5]
SMN1206 (8-pin) .018 [.45] .014 [.36] .032 [.8] .036 [.9]
SMNN1206 (10-pin) .014 [.36] .011 [.28] .032 [.8] .036 [.9]
SMN1506 (16-pin) .012 [.3] .008 [.2] .032 [.8] .039 [1]
SMN2010 (10-pin) .022 [.55] .018 [.45] .040 [1] .060[1.5]
SMN2012 (8-pin) .032 [.82] .018 [.45] .045 [1.1] .080 [2]
TYPICAL PERFORMANCE CHARACTERISTICS
Operating Temp. Range
-55°C to +150°C
Short time Overload (2.5X rated W, 5 sec)
±2%+0.1Ω max.
Resistance to Solder Heat (260°C, 10 sec)
±1%+0.1Ω max.
Moisture Res. (90-95% RH, 40°C,100 hrs)
±3%+0.1Ω max.
High Temp. Exposure (125°C, 100 hrs)
±1%+0.1Ω max.
Load Life (1000 hrs at rated W)
±3%+0.1Ω max.
Insulation Resistance
10,000 Megohm
Dielectric Withstanding Voltage
400V
P/N DESIGNATION: SMN 2010 A - 102 - J T W
Type (SMN, SMNN or ZMN)
Chip Size
Circuit Configuration: A, B, D
Resis.Code 1%: 3 signif. figures & multiplier,
e.g. 1R00=1Ω, 10R0=10Ω, 1000=100Ω, 1001=1KΩ, etc.
Resis.Code 2%-5%: 2 signif. figures & multiplier,
e.g. 1R0=1Ω, 100=10Ω, 101=100Ω, 102=1KΩ, etc.
Leave blank on ZMN zero-ohm jumper arrays (.05Ω max)
Tolerance Code: J=5%(std), G=2%, F=1%, D=0.5%
Leave blank on ZMN zero-ohm jumper arrays
Packaging: B = Bulk, T = Tape & Reel
Termination: W= Lead-free (standard), Q= Tin/Lead
(leave blank if either is acceptable)
RCD Components Inc, 520 E.Industrial Park Dr, Manchester, NH, USA 03109 rcdcomponents.com Tel: [phone] Fax: [phone] Email:[e-mail]
FA075A Sale of this product is in accordance with GF-061. Specifications subject to change without notice.
32