PLC-035D Datasheet, PDF (2/3 Pages) Qualtek Electronics Corporation – 35Watts Single Output LED Driver

35Watts Single Output LED Driver
Qualtek
Electronics Corporation
P
P C _{PLC-035 D Series}
DIMMING CONTROL
The dimmer control may be operated from an input signal of 1 – 10 Vdc.
AC/L
AC/N
AC/G
Black
White
Yellow/Green
Vout (-)
Vout (+)
PLC-035SXXXD
1-10V
GND
Implementation: DC Input
LED LAMP
DIM+ (RED)
DIM- (BLACK)
V ^1-10Vdc
Io/Ir Vs Vdim
100%
80%
60%
40%
20%
0%
0 1 2 3 4 5 6 7 8 9 10 11
Vdim(V)
Notes:
1. Io is actual output current and Ir is rated current.
2. If the dimming function is not used, please short 10 V output pin (Black) and 1-10 V input pin(Red).
The output current is about 92% Ir when the 1-10V input pin is oating.
3. For the driver to operate properly, the load voltage must be maintained above the minimum voltage threshold
(approx. 50% of the max. output voltage for any given model).
4. The dimming voltage can be tuned down to less than 1V, and the output current will be decreased to about
10% Ir; but the connected LEDs may icker. Keeping dimming voltage greater than 1V is strongly recommended.
5. Do not connect the GND of dimming to the output; otherwise, the LED driver will not work normally.
ISO-9001 Company
www.qualtekusa.com _{Page 2 of 3}