DK-CSR1011-10147-1A Datasheet, PDF (35/48 Pages) –

9.3 Input/Output Terminal Characteristics
9.3.1 Switch-mode Regulator
Switch-mode Regulator
Input voltage^(a)
Output voltage^(b)
Temperature coefficient
Normal Operation
Output noise, frequency range 100Hz to 100kHz
Settling time, settling to within 10% of final value
Output current (I_max)
Quiescent current (excluding load, I_load < 1mA)
Ultra Low-power Mode
Output current (I_max)
Quiescent current
Min
1.8
-
-200
-
-
-
-
-
-
Typ
-
1.35
-
-
-
-
-
-
-
Max
Unit
3.6
V
-
V
200
ppm/°C
0.4
mV rms
30
μs
50
mA
20
µA
100
µA
1
µA
(a) _{CSR1011 QFN is reliable and qualifiable to 4.3V (idle, active and deep sleep modes) and 3.8V (all modes), but there are minor deviations in}
performance relative to published performance values for 1.8V to 3.6V. For layout guidelines for 4.3V operation, see CSR1011 Hardware Design
Review Template.
(b) _{During Run mode, see Section 4.1.}
9.3.2 Low-voltage Linear Regulator
Normal Operation
Input voltage
Output voltage
Min
Typ
Max
Unit
0.65
-
1.35
V
0.65
-
1.20
V
Important Note:
This regulator is only for CSR internal use. Section 8 shows CSR's recommended circuit connection.
9.3.3 Digital Terminals
Input Voltage Levels
V_IL input logic level low
V_IH input logic level high
T_r/T_f
Min
-0.4
0.7 x
VDD_PADS
-
Typ
Max
Unit
-
0.3 x
VDD_PADS
V
-
VDD_PADS +
0.4
V
-
25
ns
Production Information
© Cambridge Silicon Radio Limited 2012-2015
Page 35 of 48
CS-231986-DSP6
www.csr.com