AND262HG Datasheet, PDF (1/2 Pages) Purdy Electronics Corporation – Ultra Bright LED Lamps

Weight: 0.14g
Unit: mm
AND262HG
Ultra Bright LED Lamps: Type 3
AND262HG
GaN High Brightness Green Light Emission
• 3 mm (T-1) Package
• Peak wavelength (λp = 525nm) high bright emission
• All plastic mold type, clear colorless lens
• Low drive current: 1 to 20 mA DC
• Excellent On-Off contrast ratio
• Fast response time, capable of pulse operation
• High power intensity
• High reliability
• RoHS Compliant
Maximum Ratings (T_a = 25°C)
Characteristics
Symbol
Forward Current
I_F
Reverse Voltage
V_R
Power Dissipation
P_D
Operating Temperature Range
T_Opr
Storage Temperature Range
T_Sig
Rating
30
5
120
-40 to 85
-40 to 100
Unit
mA
V
mW
C
C
Electro-Optical Characteristics (T_a = 25°C)
Characteristics
Symbol
Test Condition
Forward Voltage
V_F
Reverse Current
I_R
Luminous Intensity
I_V
Peak Emission Wavelength
λ_P
Spectral Line Half Width
∆λ
Dominant Wavelength
λd
Full Viewing Angle
θ
I_F = 20 mA
V_R = 5V
I_F = 20 mA
I_F = 20 mA
I_F = 20 mA
I_F = 20 mA
I_V = 1/2 Peak
Minimum
–
–
630
–
–
–
–
Typical
3.5
–
1,000
525
35
530
35
Maximum
4.0
50
–
–
–
–
–
Unit
V
µA
mcd
nm
nm
nm
degree
Precaution
Please be careful of the following:
1. Soldering temperature: 260 C max.
Soldering time: 5 sec. max.
Soldering portion of lead: up to 1.6 mm from the body of the device
2. The lead can be formed up to 5 mm from the body of the device without forming stress.
Soldering should be performed after the lead forming.
3. Absolute secure counter measures against static electricity and surge should be taken when handling these
products. It is recommended to use wrist band or antistatic gloves when handling these LEDs
Product specifications contained herein may be changed without prior notice.
It is therefore advisable to contact Purdy Electronics before proceeding with the design of equipment incorporating this product.
Purdy Electronics Corporation • 720 Palomar Avenue • Sunnyvale, CA 94085
Tel: [phone] • Fax: [phone] • [e-mail] • www.purdyelectronics.com
7/18/07