PCS5I9775 Datasheet, PDF (1/12 Pages) PulseCore Semiconductor – 2.5V or 3.3V, 200MHz, 14 Output Zero Delay Buffer

September 2006
rev 0.4
2.5V or 3.3V, 200MHz, 14 Output Zero Delay Buffer
PCS5I9775
General Features
• Output frequency range: 8.3MHz to 200MHz
• Input frequency range: 4.2MHz to 125MHz
• 2.5V or 3.3V operation
• Split 2.5V/3.3V outputs
• 14 Clock outputs: Drive up to 28 clock lines
• 1 Feedback clock output
• 2 LVCMOS reference clock inputs
• 150pS max output-output skew
• PLL bypass mode
• ‘SpreadTrak’
• Output enable/disable
• Industrial temperature range: -40°C to +85°C
• 52 Pin 1.0 mm TQFP Package
• RoHS Compliance
Functional Description
The PCS5I9775 is a low-voltage high-performance
200MHz PLL-based zero delay buffer designed for
high-speed clock distribution applications. The
PCS5I9775 features two reference clock inputs and
provides 14 outputs partitioned in 3 banks of 5, 5, and 4
outputs. Bank A and Bank B divide the VCO output by 4
or 8 while Bank C divides by 8 or 12 per SEL(A:C)
settings, see Functional Table. These dividers allow
output to input ratios of 6:1, 4:1, 3:1, 2:1, 3:2, 4:3, 1:1,
and 2:3. Each LVCMOS compatible output can drive 50Ω
series or parallel terminated transmission lines. For series
terminated transmission lines, each output can drive one
or two traces giving the device an effective fanout of 1:28.
The PLL is ensured stable, given that the VCO is
configured to run between 200MHz and 500MHz. This
allows a wide range of output frequencies from 8.3MHz to
200MHz. For normal operation, the external feedback
input, FB_IN, is connected to the feedback output,
FB_OUT. The internal VCO is running at multiples of the
input reference clock set by the feedback divider, see
Frequency Table. When PLL_EN is LOW, PLL is
bypassed and the reference clock directly feeds the
output dividers. This mode is fully static and the minimum
input clock frequency specification does not apply.
Block Diagram
VCO_SEL (1, 0)
PLL_EN
TCLK_SEL
TCLK0
TCLK1
FB_IN
SELA
SELB
SELC
CLK_STP#
FB_SEL(1.0)
MR#/OE
.
÷2
PLL
200-
÷4
500MHZ
÷2/÷4
CLK
STOP
÷2/÷4
CLK
STOP
÷4/÷6
CLK
STOP
÷4/÷6/÷8/÷12
QA0
QA1
QA2
QA3
QA4
QB0
QB1
QB2
QB3
QB4
QC0
QC1
QC2
QC3
FB_OUT
PulseCore Semiconductor Corporation
1715 S. Bascom Ave Suite 200, Campbell, CA 95008 • Tel: [phone] • Fax: [phone]
www.pulsecoresemi.com
Notice: The information in this document is subject to change without notice.