DASUTCC500NF Datasheet, PDF (20/21 Pages) Pulse A Technitrol Company – UltraThin, clear radome antenna for iDAS

Series: CLARITY
Description: UltraThin, clear radome
antenna for iDAS
PART NUMBER: DASUTCCxxx
ASSEMBLY
Installation
1. Drill or cut a hole 2.5-2.75 inches (64-70 mm) diameter at the center of the
ceiling tile or at the desired location. Slide the antenna cable/connector
assembly through the hole. Slide the Collar and Nut onto the cable. Turn the
Nut, tightening the antenna against the ceiling tile. See
Note: Fiberboard ceiling tile is soft; tighten the nut just enough to hold the
antenna firmly in place.
If using the reflector, thread the reflector onto the Antenna Stem before
attaching the connectors. See Figure 2.
Issue:1651
In the effort to improve our products, we reserve the right to make changes judged to be necessary.
20
CONFIDENTIAL AND PROPRIETARY INFORMATION
This document contains confidential and proprietary information of Pulse Electronics, Inc. (Pulse) and is protected by copyright, trade secret and other state and federal laws.
Its receipt or possession does not convey any rights to reproduce, disclose its contents, or to manufacture, use or sell anything it may describe. Reproduction, disclosure or
use without specific written authorization of Pulse is strictly forbidden.