PA4390.101HLT Datasheet, PDF (1/3 Pages) Pulse A Technitrol Company – Power Beads - PA4390.XXXHLT Series

Pulse Jack
SMT Power Inductors
Power Beads - PA4390.XXXHLT Series
Current Rating: Over 100Apk ^{E l e c t r o n i c s}
Inductance Range: 100nH to 330nH
Height: 10.0mm Max
Footprint: 10.0mm x 7.0mm Max
Halogen Free
Part
Number
PA4390.101HLT
PA4390.121HLT
PA4390.151HLT
PA4390.331HLT
Inductance¹
@ 0ADC
(nH +/- 15%)
100
120
150
330
Electrical Specifications @ 25°C — Operating Temperature - 40°C to +130°C ⁷
Inductance²
@Irated
(nH TYP)
Irated ³
(ADC)
DCR ⁴
(mΩ nominal)
25°C
Saturation Current ⁵
(A TYP)
100°C
125°C
100
68
113
86
81
120
150
68
68
0.185+/-10%
94
80
81
75
78
73
310
33
43
33
31
Heating Current⁶
(A TYP)
68
NOTES:
1. Inductance measured at 100kHz, 100mVrms.
2. Inductance at Irated is the value of the inductance at 25°C at the listed rated current.
3. The rated current as listed is either the saturation current (25°C or 100°C) or the heating current depending on
which value is lower.
4. The nominal DCR is measured from point a to point b , as shown below on the mechanical drawing.
5. The saturation current is the typical current which causes the inductance to drop by 20% at the stated ambient
temperatures (25°C, 100°C ). This current is determined by placing the component in the specified ambient envi-
ronment and applying a short duration pulse current
(to eliminate self-heating effects) to the component.
6. The heating current is the DC current which causes the part temperature
to increase by approximately 40°C when used in a typical application.
Mechanical
PA4390.XXXHLT
7. In high volt*time applications, additional heating in the component can occur due to core losses in the inductor
which may neccessitate derating the current in order to limit the temperature rise of the component. To deter-
mine the approximate total losses (or temperature rise) for a given application, the coreloss and temperature
rise curves can be used.
8. Parts with the HLT suffix are sold in tape and reel packaging. Pulse complies to industry standard tape and reel
specification EIA-481.
The tape and reel for this product has a width (W=24mm), pitch (Po=16mm) and depth (Ko=10.5mm). Samples of
these parts can be ordered by removing the HLT suffix and replacing with HL.
9. The temperature of the component (ambient plus temperature rise) must be within the stated operating tem-
perature range.
Schematic
PA4390.XXXHL
D/C CTRY
1
pulseelectronics.com
Weight .......... 2.74/grams
Tape & Reel ......... 300/reel
Dimensions: mm
Unless otherwise specified,
all tolerances are ± 0,25
P765.D (06/16)