PA4085.121HL Datasheet, PDF (1/3 Pages) Pulse A Technitrol Company – Power Beads - PA4085.XXXHL Series

Pulse Jack
SMT Power Inductors
Power Beads - PA4085.XXXHL Series
Designed for use with Infineon^® DrBlade 2.0^{E l e c t r o n i c s}
Current Rating: Over 94 Apk
Inductance Range: 120nH to 180nH
Height: 9.2 mm Max
Footprint: 11.0mm x 8.2mm Max
Halogen Free _{Electrical Specifications @ 25°C — Operating Temperature -40°C to +130°C7}
Part
Number
Inductance¹
@ 0ADC
(nH +/- 10%)
Inductance²
@Irated
(nH TYP)
Irated ³
(ADC)
Y _PA4085.121HL
120
120
84
PA4085.151HL
150
148
65
PA4085.181HL
180
163
58
DCR ⁴
(mΩ nominal)
0.18 +/- 5%
Saturation Current ⁵
(A TYP)
25°C
100°C
94
84
84
65
72
58
Heating Current⁶
(A TYP)
70
R _NOTES:
1. Inductance measured at 100kHz, 100mVrms.
2. Inductance at Irated is the value of the inductance at 25°C at the listed rated current.
A 3. The rated current as listed is either the saturation current (25°C or 100°C) or the heating current depending on
which value is lower.
4. The nominal DCR is measured from point a to point b , as shown below on the mechanical drawing.
5. The saturation current is the typical current which causes the inductance to drop by 20% at the stated ambient
IN ^{temperatures (25°C, 100°C and 125°C). This current is determined by placing the component in the specified ambi-}
ent environment and applying a short duration pulse current
(to eliminate self-heating effects) to the component.
6. The heating current is the DC current which causes the part temperature
PA4085.XXXHL _PR^Mech_E^anical _LIM ^{Schematic toincreasebyapproximately40°Cwhenusedinatypicalapplication.}
7. In high volt*time applications, additional heating in the component can occur due to core losses in the inductor
which may neccessitate derating the current in order to limit the temperature rise of the component. To deter-
mine the approximate total losses (or temperature rise) for a given application, the coreloss and temperature
rise curves can be used.
8. Optional Tape & Reel packaging can be ordered by adding a “T” suffix to the part number (i.e. PA4085.XXXHL
becomes PPA4085.XXXHLT).
Pulse complies to industry standard tape and reel specification EIA481. The tape and reel for this product has a
width (W=24mm), pitch (Po=16.0mm) and depth (Ko=8.2mm).
9. The temperature of the component (ambient plus temperature rise) must be within the stated operating tem-
perature range.
Weight . . . . . . . . . . . . . . . . . . . . . . . .2.75 grams
Tape & Reel . . . . . . . . . . . . . . . . . . . . . . 450/reel
Dimensions: mm
Unless otherwise specified,
all tolerances are ± 0,25
1
pulseelectronics.com
PRELIMINARY P750.A (4/15)