PA4060.121HL Datasheet, PDF (1/2 Pages) Pulse A Technitrol Company – Power Beads - PA4060.XXXHL

SMT POWER INDUCTORS
Power Beads - PA4060.XXXHL
Current Rating: Over 90Apk
Inductance Range: 115nH to 300nH
Height: 7.5mm Max
Footprint: 10.4mm x 8.0mm Max
Halogen Free
Electrical Specifications @ 25°C — Operating Temperature - 40°C to +130°C ⁷
Part
Number
PA4060.121HL
PA4060.151HL
PA4060.171HL
PA4060.231HL
PA4060.271HL
PA4060.301HL
Inductance¹
@ 0ADC
(nH +/- 15%)
115
150
175
238
270
305
Inductance
@Irated
(nH TYP)
115
150
175
220
250
290
Irated ²
(ADC)
41
41
41
38.5
32.5
27
DCR ³
(mW nominal)
0.29 +/- 5%
25°C
94
76
67
48
41
35
Saturation Current ⁴
(A TYP)
100°C
91
63
53
38.5
32.5
27
125°C
79
59.5
48.5
36
30.5
26
Heating Current
(A TYP)
41
Y _NOTES:
1. Inductance measured at 100kHz, 100mVrms.
2. The rated current as listed is either the saturation current at 100�C or the
heating current depending on which value is lower.
R 3. The nominal DCR is measured from point a to point b , as shown below
on the mechanical drawing.
4. The saturation current is the typical current which causes the inductance
A _{to drop by 20% at the stated ambient temperatures (25°C, 100�C and}
125°C). This current is determined by placing the component in the
specified ambient environment and applying a short duration pulse current
(to eliminate self-heating effects) to the component.
Mechanical IN 5. The heating current is the DC current which causes the part temperature
to increase by approximately 40°C.
6. In high volt*time applications, additional heating in the component can
occur due to core losses in the inductor which may neccessitate derat-
ing the current in order to limit the temperature rise of the component. To
determine the approximate total losses (or temperature rise) for a given
application, the coreloss and temperature rise curves can be used.
7. Optional Tape & Reel packaging can be ordered by adding a “T” suf-
fix to the part number (i.e. PA4060.151HL becomes PA4060.151HLT).
Pulse complies to industry standard tape and reel specification EIA481.
The tape and reel for this product has a width (W=24mm), pitch
(Po=12.0mm) and depth (Ko=8.4mm).
8. The temperature of the component (ambient plus temperature rise) must
be within the stated operating temperature range.
Schematic _PA4060.XXXHL
P.XAX4X0N60L _LIM ¹
D/C
2
PRE^CTRY
b
a
Weight . . . . . . . . . . .2.4 grams
Tape & Reel . . . . . . . . . 450/reel
Dimensions: mm
Unless otherwise specified,
all tolerances are ± 0,25
1
pulseelectronics.com
PRELIMINARY P752.A (10/14)