PA4025.151HL Datasheet, PDF (1/3 Pages) Pulse A Technitrol Company – Power Beads - PA4025.XXXHL Series

Pulse Jack
SMT Power Inductors
Power Beads - PA4025.XXXHL Series
Current Rating: Over 86Apk
Inductance Range: 150nH to 360nH
Height: 12.3mm Max
Footprint: 10.0mm x 6.8mm Max
Halogen Free
Electronics
Electrical Specifications @ 25°C — Operating Temperature - 40°C to +130°C ⁷
Part
Number
Inductance¹
@ 0ADC
(nH +/- 10%)
Inductance²
@Irated
(nH TYP)
Irated ³
(ADC)
PA4025.151HL
150
150
58
PA4025.181HL
180
180
58
PA4025.231HL
230
185
62
PA4025.361HL
360
350
36
PA4025.471HL
470
460
25
DCR ⁴
(mW nominal)
0.29 +/- 10%
Saturation Current ⁵
(A TYP)
25°C
100°C
75+
75+
75+
75+
75
62
46
36
35
25
Heating Current⁶
(A TYP)
58
NOTES:
1. Inductance measured at 100kHz, 100mVrms.
2. Inductance at Irated is the value of the inductance at 25°C at the listed rated current.
3. The rated current as listed is either the saturation current (25°C or 100°C) or the heating current depending on
which value is lower.
4. The nominal DCR is measured from point a to point b , as shown below on the mechanical drawing.
5. The saturation current is the typical current which causes the inductance to drop by 20% at the stated ambient
temperatures (25°C, 100°C ). This current is determined by placing the component in the specified ambient envi-
ronment and applying a short duration pulse current
(to eliminate self-heating effects) to the component.
6. The heating current is the DC current which causes the part temperature
to increase by approximately 40°C when used in a typical application.
7. In high volt*time applications, additional heating in the component can occur due to core losses in the inductor
which may neccessitate derating the current in order to limit the temperature rise of the component. To deter-
mine the approximate total losses (or temperature rise) for a given application, the coreloss and temperature
rise curves can be used.
8. Optional Tape & Reel packaging can be ordered by adding a “T” suffix to the part number (i.e. PA4025.361HL
becomes PA4025.361HLT).
Pulse complies to industry standard tape and reel specification EIA481. The tape and reel for this product has a
width (W=32mm), pitch (Po=16mm) and depth (Ko=13mm).
9. The temperature of the component (ambient plus temperature rise) must be within the stated operating tem-
perature range.
Mechanical
Schematics
PA4025.XXXHL
M1
CN
1
pulseelectronics.com
Weight . . . . . . . . . . . . xx grams
Tape & Reel . . . . . . . . . . xx/reel
Dimensions:
Inches
mm
Unless otherwise specified,
all tolerances are ± ^.010
0,25
P733.B (02/15)