PA3136.101HL Datasheet, PDF (1/2 Pages) Pulse A Technitrol Company – Power Beads - PA3136.XXXHL Series

SMT Power Inductors
Power Beads - PA3136.XXXHL Series
Part Number
Inductance ¹
@ 0Adc
(nH ±15%)
Current Rating: Over 90Apk
Inductance Range: 110nH to 235nH
Height: 4.0mm Max
Footprint: 13.8mm x 8.0mm Max
Halogen Free
Electrical Specifications @ 25°C — Operating Temperature -40°C to +130°C ⁸
Inductance
@ Irated
(nH TYP)
Irated ²
(ADC)
DCR ³
(mΩ nominal)
Saturation Current ⁴
(A TYP)
25 ºC
100 ºC
Heating Current ⁵
(A TYP)
PA3136.101HL
110
88
49
PA3136.121HL
120
96
46
PA3136.141HL
140
112
38
PA3136.161HL
160
128
34
PA3136.181HL
180
144
29
PA3136.211HL
210
168
25
PA3136.241HL
235
188
22.5
Notes:
1. Inductance measured at 100kHz, 100mArms.
2. The rated current as listed is either the saturation current or the heating current depending on which
value is lower.
3. The nominal DCR is measured from point a to point b , as shown below on the mechanical drawing.
4. The saturation current is the typical current which causes the inductance to drop by 20% at the stated
ambient temperatures (25°C and 100°C). This current is determined by placing the component in the
specified ambient environment and applying a short duration pulse current
(to eliminate self-heating effects) to the component.
5. The heating current is the DC current which causes the part temperature
to increase by approximately 40°C.
Mechanicals
PA3136.XXHL
60
49
53
46
45
38
0.23 +/- 10%
40
34
50
34
29
30
25
26
22.5
6. In high volt*time applications, additional heating in the component can occur due to core losses in
the inductor which may neccessitate derating the current in order to limit the temperature rise of the
component. To determine the approximate total losses (or temperature rise) for a given application,
the coreloss and temperature rise curves can be used.
7. Optional Tape & Reel packaging can be ordered by adding a “T” suffix to the part number (i.e.
PA3136.121HL becomes PA3136.121HLT).
Pulse complies to industry standard tape and reel specification EIA481. The tape and reel for this prod-
uct has a width (W=24mm), pitch (Po=12.0mm) and depth (Ko=3.80mm).
8. The temperature of the component (ambient plus temperature rise) must be within the stated oper-
ating temperature range.
Schematics
Weight...........................2.0 grams
Tape and Reel....................1250/tray
Dimensions:
Inches
mm
Unless otherwise specified, all tolerences are ±
.010
0,25
D/C CTRY
1
pulseelectronics.com
P703.A (9/11)