PA2509NL Datasheet, PDF (1/2 Pages) Pulse A Technitrol Company – Power Beads - PA2509NL Series

SMT Power Inductors
Power Beads - PA2509NL Series
Current Rating: Over 75Apk
Inductance Range: 70nH to 200nH
Height: 8.0mm Max
Footprint: 7.0mm x 8.5mm Max
Electrical Specifications @ 25°C - Operating Temperature -40°C to +130°C ⁷
Inductance
Inductance
Part
@ 0ADC
@ Irated
Irated ¹
DCR²
Number
(nH ±10%)
(nH TYP)
(ADC)
(m )
Saturation Current³
(A TYP)
25°C
100°C
Heating ⁴
Current
(A TYP)
PA2509.700NL
70
70
30
107
75+
PA2509.900NL
90
90
30
83
75
PA2509.101NL
105
105
30
75
0.35 ±8.5%
66
33
PA2509.121NL
120
120
30
64
58
PA2509.161NL
160
160
30
48
43
PA2509.201NL
200
190
30
36
31
Notes:
1. The rated current as listed is either the saturation current or the heating current depending 5. In high volt*time applications, additional heating in the component can occur due to
on which value is lower.
core losses in the inductor which may necessitate derating the current in order to limit
2. The nominal DCR is measured from point a to point b , as shown on the mechanical
the temperature rise of the component. To determine the approximate total losses (or
drawing below.
temperature rise) for a given application, the coreloss and temperature rise curves can
3. The saturation current is the typical current which causes the inductance to drop by 20% at be used.
the stated ambient temperatures (25°C and 100°C). This current is determined by placing the 6. Optional tape and reel packaging can be ordered by adding a “T” su x to the part
component in the specified ambient environment and applying a short duration pulse
number (i.e. PA2509.121NL becomes PA2509.121NLT). Pulse complies to industry
current (to eliminate self-heating e ects) to the component.
standard tape and reel specification EIA481. The tape and reel for this product has a
4. The heating current is the DC current which causes the part temperature to increase by
width (W=24mm), pitch (Po=16.0mm) and depth (Ko=8.9mm).
approximately 40°C. This current is determined by soldering the component on a typical 7. The temperature of the component (ambient plus temperature rise) must be within the
application PCB, and then applying the current to the device for 30 minutes.
stated operating temperature range.
Mechanical
Schematic
PA2509.XXXNL
USA 858 674 8100 Germany 49 2354 777 100 Singapore 65 6287 8998
1
pulseelectronics.com
Weight ................................1.5 grams
Tape & Reel .........................500/reel
Dimensions:
Inches
mm
Unless
otherwise
specified,
all
tolerances
are
±
.010
0,25
Shanghai 86 21 62787060 China 86 755 33966678 Taiwan 886 3 4356768
P672.D (06/16)