PA2202.121NL Datasheet, PDF (1/2 Pages) Pulse A Technitrol Company – SMT Power Inductors

SMT Power Inductors
Power Beads - PA2202.XXXNL Series
Current Rating: Over 75Apk
Inductance Range: 120nH to 360nH
Height: 6.0mm Max
Footprint: 12.1mm x 10.0mm Max
Part
Number
Inductance
@0ADC
(nH ±15%)
Electrical Specifications @ 25°C — Operating Temperature - 40°C to +130°C ⁷
Inductance
@Irated
(nH TYP)
Irated ¹
(ADC)
DCR ²
(mΩ)
Inductance
@Isat
(nH TYP)
Inductance
@Isat
(nH MIN)
Saturation Current ³
(A TYP)
25°C
100°C
Heating ⁴
Current
(A TYP)
PA2202.121NL
120
120
36
PA2202.181NL
180
180
36
PA2202.211NL
215
PA2202.231NL
230
215
230
36
36
0.48 ± 6.5%
PA2202.321NL
325
282
31
PA2202.361NL
365
315
27
NOTES:
1. The rated current as listed is either the saturation current or the heating current depending on
which value is lower.
2. The nominal DCR is measured from point a to point b , as shown below on the mechanical
drawing.
3. The saturation current is the typical current which causes the inductance to drop by 20% at the
stated ambient temperatures (25°C and 100°C). Inductance at Isat is the minimum inductance
when measured at Isat (25°C and 100°C).This current is determined by placing the component in
the specified ambient environment and applying a short duration pulse current (to eliminate self-
heating effects) to the component.
4. The heating current is the DC current which causes the part temperature to increase by
approximately 40°C. This current is determined by soldering the component on a typical
application PCB, and then applying the current to the device for 30 minutes.
96
78
84
75
144
117
64
52
172
140
53
47
184
150
47
44
36
260
211
34
31
292
237
30
27
5. In high volt*time applications, additional heating in the component can occur due to core losses
in the inductor which may neccessitate derating the current in order to limit the temperature rise
of the component. To determine the approximate total losses (or temperature rise) for a given
application, the coreloss and temperature rise curves can be used.
6. Optional Tape & Reel packaging can be ordered by adding a “T” suffix to the part number
(i.e. PA2202.121NL becomes PA2202.121NLT). Pulse complies to industry standard tape and reel
specification EIA481.
7. The temperature of the component (ambient plus temperature rise) must be within the stated
operating temperature range.
PA2202.XXXNL
Mechanical
Schematic
1
2
.250
6,35
Weight . . . . . . . . . . . . . . . . . . . .2.7 grams
Tape & Reel . . . . . . . . . . . . . . . . . 600/reel
1
Dimensions: Inches
mm
Unless otherwise specified,
all tolerances are ± .010
0,25
pulseelectronics.com
.486
12,35
TAPE & REEL
.402
LAYOUT
10,20
.945
24,00
.630
16,00
USER DIRECTION
OF FEED
P664.E (02/13)