PE42510AMLI-Z Datasheet, PDF (3/7 Pages) Peregrine Semiconductor – SPDT High Power UltraCMOS® Reflective RF Switch 30 - 2000 MHz

PE42510A
Product Specification
Evaluation Kit
The PE42510A Evaluation Kit board was designed
to ease customer evaluation of the PE42510A
RF switch.
Figure 4. Evaluation Board Layouts
DC power is supplied through J10, with V_DD on pin 9,
and GND on the entire lower row of even numbered
pins. To evaluate a switch path, add or remove
jumpers on CTRL/V1 (pin 3) using Table 5 (adding
a jumper pulls the CMOS control pin low and
removing it allows the on-board pull-up resistor to
set the CMOS control pin high). J10 pins 1, 11, and
E _{13 are N/C.}
The RF common port (RFC) is connected through
a 50Ω transmission line via the top SMA connector,
T _{J1. RF1 and RF2 paths are also connected through}
50 Ω transmission lines via SMA connectors. A 50 Ω
through transmission line is available via SMA
connectors J8 and J9. This transmission line can be
E ^{used to estimate the loss of the PCB over the}
environmental conditions being evaluated. An open-
ended 50 Ω transmission line is also provided at J7
for calibration if needed.
OBSOL ^{Figure 5. Evaluation Board Schematic}
101-0314-02
Document No. 70-0266-03 │ www.psemi.com
102-0383-02
©2008-2012 Peregrine Semiconductor Corp. All rights reserved.
Page 3 of 7