PAM22LOPR2268 Datasheet, PDF (2/10 Pages) Protek Devices – LoPro™ Dual SPDT Analog Switch

ANALOG PRODUCTS DIVISION
Absolute Maximum Ratings⁽¹⁾
Supply Voltage VCC ....................................................4.5V
DC Switch Voltage (VS)⁽²⁾ ....................................VCC +0.5V
DC Input Voltage (VIN)(2) .............................................4.5V
Analog Signal Range.....................Min -1.0 to Max VCC +1.0
Continuous Current NO_NC_COM_ ...............±300mA Peak
Current NO_NC_COM_
(pulsed at 1ms 50% duty cycle) ....................±400mA Peak
Current NO_NC_COM_
(pulsed at 1ms 10% duty cycle) ........................... ±500mA
Storage Temperature Range (TSTG) .. …..–65°C to +150°C
Junction Temperature under Bias (TJ)..........................150°C
Junction Lead Temperature (TL)
(Soldering, 10 seconds).............................................260°C
Power Dissipation (PD) @ +85°C ........................ …250mW
PAM22LOPR2268
LoPro^™ Dual SPDT Analog Switch
Recommended Operating Conditions⁽³⁾
Supply Voltage Operating (V_CC) ………………………1.8V to 4.2V
Control Input Voltage (V_IN)……………….. 0V to VCC Switch Input
Voltage (V_IN)…………………………. -0.3V to VCC Output Voltage
(V_OUT)……………………………………………………… 0V to VCC
Operating Temperature (T_A)………………………... –40°C to +85°C
Input Rise and Fall Time (tr,tf)
Control Input VCC = 2.3V - 3.6V………………..0ns/V to 10ns/V
Thermal Resistance (θ_JA)………………………………….350°C/W
Lead Temperature (soldering 10s)……………………… .+240°C
Bump Temperature (soldering notes)
Infrared (15s)……………………………………………..….+220°C
Vapor Phase (60ns)………………………………………….+215°C
Notes:
1. "Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress only rating and operation of the device at these or any
other conditions beyond those indicated in the operational sections of this specification is not implied.
2. The input and output negative voltage ratings may be exceeded if the input and output diode current ratings are observed.
3. Control input must be held HIGH or LOW; it must not float.
4. Internal Resistance RTERM is guaranteed by design and not production tested.
Capacitance
Parameter
NC Off Capacitance
NO Off Capacitance
NC On Capacitance
NO On Capacitance
Symbol Test Conditions
C_NC(OFF) f =1MHz, See Test Circuit Figure7.
C_NO(OFF) f =1MHz, See Test Circuit Figure7.
C_NC(ON) f =1MHz, See Test Circuit Figure8.
C_NO(ON) f =1MHz, See Test Circuit Figure8.
Min Typ
35
35
95
95
Max Unit
pF
2
2929 S Fair Lane, Tempe, AZ, 85282 Tel: [phone]. Fax: [phone]
www.protekdevices.com
95006 Rev0.01/12
NOT FOR USE IN LIFE SUPPORT SYSTEMS