EPR-16 Datasheet, PDF (27/36 Pages) Power Integrations, Inc. – Engineering Prototype Report for EP-16 2.75 W Charger/Adapter Using LNK501

17-May-04
EPR-16 – LinkSwitch 2.75 W Charger/Adapter
10 Appendix A – EP-16 Enclosure Opening Procedures
10.1 Method 1 - Non-destructive
Step 1:
Insert thin bladed
screwdrivers into slots in
the AC connect portion of
case. Make certain
screwdriver is on top of
plastic tab.
Step 2:
Insert thin bladed
screwdriver between two
halves of the case and
twist. Case will pop apart.
Repeat on other side and
pull to separate.
Figure 28 – Non-destructive Opening of EP-16 Case.
10.2 Method 2 - Destructive
Step 1:
Using diagonal cutter clip plastic
and lift up as shown. Repeat on
both sides of case (4 places). Case
will then separate.
Figure 29 - Destructive Opening of EP-16 Case.
Page 27 of 36
Power Integrations
Tel: [phone] Fax: [phone]
www.powerint.com