SKYLLA Datasheet, PDF (1/2 Pages) Powerbox – T H R E E S T E P B AT T E R Y C H A R G E R

Skylla TG Series
THREE STEP BATTERY CHARGER
FEATURES
• 720W - 2400W
• 24V and 48V Systems
• Three Step Charger
• Temp Compensation
• On 24V models 2 separate outputs
• Charge 2 battery banks
• Corrosion Resistant
SPECIFICATIONS
INPUT
PROTECTION
Input voltage
Input frequency
1ph: 185-264Vac
3ph: 320-450Vac 180-400Vdc
45 - 65Hz
Power factor
1.0
OUTPUT
Optimum absorption charge and float charge voltages
Battery Charging
for Flooded Lead-acid, Gel-Cell or AGM batteries.
Selectable by dip switch
Absorption
Charge
voltage
28.5Vdc and 57Vdc
See selection table.
Float Charge voltage
26.5Vdc and 53Vdc
See selection table.
Two outputs to charge 2 battery banks (24V models
only). The TG chargers feature 2 isolated outputs. The
Two Outputs
second output is limited to approx 4A and with a
slightly lower output voltage. It is intended to top up a
starter battery.
See selection table.
Total output ammeter Yes.
Charge characteristic
Accurately controls the charging in 3 steps. Charges
more rapidly than other processes
Short circuit
Battery connection
Battery voltage
Over temperature
STANDARDS
Safety
Emission
Immunity
C-tick
ENVIRONMENTAL
Operating temperature
Derating
Cooling
Humidity
MECHANICAL
Temperature sensor
Battery Monitor
Skylla Control
Charger switch
Battery temperature sensor supplied. When
connected charge voltage will automatically decrease
with increasing battery temperature.
The BMV 600S battery monitor features an advanced
control and measuring system for battery voltage and
charge/discharge current. The battery monitor
selectively displays battery voltage, current,
consumed AH or time to go.
The Skylla Control allows you to alter the charge
current and see the system status
A remote on-off switch
AC connection
Battery connection
Protection category
Material & colour
Size & Weight
Remote alarm
Potential free contacts 60V / 1A (1 x NO & 1 x NC)
APPLICATION
Yes. output short circuit protection
Yes, battery reverse polarity detection
Yes, battery voltage too high
Yes, temperature too high protection
EN60335-1, EN60335-2-29.
EN55014, EN61000-3-2
EN55014-2, EN61000-3-3
AS/NZS CISPR11: Group 1, Class A.
-20°C to 60°C.
Full load up to 40C ambient, Output will reduce to
approximately 80% of nominal at 50C and 60% of
nominal at 60C
Temperature and current controlled fan.
95% max (non condensing).
Screw-clamp 2-5mm² (AWG 6)
M8 studs
IP21.
Aluminum epoxy powder coated cases (blue RAL 5012),
Stainless steel fixings
24/30TG-24/50TG: 365x250x147mm, 5.5Kg
24/50TG 3Phase: 365x250x257mm, 13Kg
24/80TG: 365x250x257mm, 10Kg
24/100TG: 365x250x257mm, 10Kg
24/100TG 3Phase: 515x260x265mm, 23Kg
48/25TG: 365x250x147mm, 5.5Kg
48/50TG: 365x250x257mm, 10Kg
Doc. No. Skylla Rev.B 23-11-15