DVC500 Datasheet, PDF (1/2 Pages) Powerbox – D C / D C A U T O M O T I V E C O N V E R T E R

DVC500 Series
DC/DC AUTOMOTIVE CONVERTER
FEATURES
• 500W Automotive and Vehicle Converter
• Designed for use in rough environment
• Rugged construction / potted device
• Protection against unfavourable environmental conditions
• DC/DC wide range input
• Filtered against vehicle on-board disturbances
• Galvanic separation 1.5kV
• Design acc. to EN60950. EN50155. EN1175. ISO20898
• Regulated output
• Very high efficiency
• Short-circuit / No-load protection
• Over Temperature protection
• Parallel connectable (Option: Smart output characteristics)
SPECIFICATIONS
INPUT
Input voltage
Input range
Filtering
OUTPUT
Output voltage
Output Voltage Tolerance
Output Current
Current Limiting
Load Regulation
Regulation time
Line regulation
Temperature drift
Ripple & noise
Efficiency
Parallel Operation
ENVIRONMENT
Ambient temperature
Storage temperature
Humidity
Cooling
36V, 48V, 72V, 96V, 110V
See selection table
Filtering against on board disturbances
12.5Vdc, 13.8Vdc, 24.3Vdc
+/- 1%
See Selection Table
Typically 1.1 x I nominal
+/-0.5% (Typ 0.3% = 80mV) 10-90% load
<1 ms
±0.1%
-25C to +70C <1%
100mVp-p
92% Typical
Unlimited, 100% redundancy
requires external diodes
-40°C to 75°C with derating,
Max baseplate temperature 100°C
-40°C to 85°C
100% relative humidity, dewing permitted.
Natural convection / cooling
via contact to mounting surface.
STANDARDS & APPROVALS
Safety
EN60950, EN50155, EN1175, ISO20898
EMC
EN61204-3
PROTECTION
Protective degree
IP67 (not connector)
Reverse polarity Protection
External input fuse is blown.
Over temperature Protection Protective shut down, self reset after cool down.
Insulation
Input to Output: 1.5kV
Input to Case: 1.5kV
Ouput to Case: 500V
Over voltage Protection
Protective shut down
Self reset after cool down.
Safety Note
If an external energy source (e.g battery) is
connected to the output of the converter, the
supply line (+pole)must be fused close by the
source. Recommended fusing: 1.1.. 1.2 x Inom
MECHANICAL
Connectors
Input: +Uin (M5) / -Uin(M8)
Output: +Uout (M6) / -Uout(M8)
Dimensions
222(220) x 166(122) x 71(47)mm
Weight
2.65Kg
Case Material
Aluminium
www.powerbox.com.au - 1800 251 380
www.powerbox.co.nz - 0800 104 480
Doc. No. DVC500 Rev.D 25-11-15