CENTAUR Datasheet, PDF (1/2 Pages) Powerbox – T H R E E S T E P B AT T E R Y C H A R G E R

Centaur Series
THREE STEP BATTERY CHARGER
FEATURES
• 240W - 1440W
• 12V and 24V Battery Systems
• Three Step Charger
• Temperature Compensation
• Three Separate Outputs
• Charge 3 battery banks
• Corrosion Resistant
SPECIFICATIONS
INPUT
Input Voltage
Input Frequency
Power Factor
OUTPUT
Battery Charging
Absorption Charge Voltages
Float Charge Voltages
Three Outputs
Total Output Ammeter
Charge Characteristic
Temperature Sensor
Battery Monitor
Battery Alarm
90 - 265Vac
90 - 400Vdc
45 - 65Hz
1.0
Optimum absorption charge and float voltages
for Flooded Lead-acid, Gel-Cell or AGM batteries.
Selectable by dip switch
14.3Vdc and 28.5Vdc
See selection table
13.5Vdc and 27.0Vdc
See selection table
3 isolated outputs that each can supply up to the
fully rated current. Combined total rated current
cannot be exceeded. Keeping within the total
power rating of the battery charger.
Yes.
Charges at the absorption rate, until the output
has reduced to 70% of rated current. At which
time a 4hour timer begins, then the charger
switches to float rate
Internal, -2mV/°C per cell.
The BMV-700 battery monitor features an
advanced control and measuring system for
battery voltage and charge/discharge current.
The battery monitor displays battery voltage,
current, consumed AH or time to go.
An excessively high or low battery voltage is
indicated by an audible and visual alarm
PROTECTION
Ignition Protected
Yes.
Short Circuit Protection Yes.
Over Temperature Protection Yes.
STANDARDS
Safety
EN60335-1, EN60335-2-29, UL1236.
Emission Immunity
EN55014, EN61000-3-2
Automotive Directive
EN55012-2, EN61000-3-3
C-tick
AS/NZS CISPR11: Group 1, Class A.
ENVIRONMENTAL
Operating Temperature
Derating
-20°C to +60°C.
Full load up to 40C ambient, Output will reduce to
approximately 80% of nominal at 50C and 60% of
nominal at 60C
Cooling
Temperature and current controlled fan.
Humidity
95% max (non condensing).
MECHANICAL
AC Connection
Screw-clamp 4mm² (AWG 6)
Battery Connection
M6 or M8 studs
See selection table
Protection Category
Material & Colour
IP21.
Aluminium epoxy powder coated cases (blue RAL
5012), Stainless steel fixings
Size & Weight
12/20-12/30: 355 x 215 x 110mm, 3.8Kg
12/40-12/60, 24/30: 426 x 239 x 135mm, 5Kg
12/80-12/100, 24/40-24/60: 505 x 255 x 130m, 12Kg
12/200, 24/80-24/100: 505 x 255 x 230mm, 16Kg
APPLICATION
Doc. No. Centaur Rev.A 19-10-15