CXA-P1012-NJL Datasheet, PDF (4/4 Pages) Power Systems GmbH+Co.KG – DC-AC INVERTER UNIT 9.0W DUAL OUTPUTS

DC-AC INVERTER UNIT
CXA-P1012-NJL (9.0W DUAL OUTPUTS)
(PRELIMINARY INFORMATION)
Note 1. For circuit connection, please prefer to test circuit diagram.
Note 2. Please use minimum of 2mm clearance (all directions) between inverter high voltage area and any
conductors. Please refer to mechanical drawing for marking of high voltage area.
Note 3. Open voltage (strike voltage) is measured across the transformer secondary winding at no load as the
reading at the output connector would be less than the actual value.
Note 4. The output of this dc-ac inverter is insulated in electricity with the input part.
Please use CN2-3 and CN3-3 side when you connect the Vlow side of the output with the ground.
Note 5.
Please use the screw of the insulator to prevent the electrical discharge or make the installation. Screw the
first side and an insulated structure in electricity because the output pattern of a high voltage is laid out to
be near when you use the installation hold of part b in the externals dimensional drawing.
Note 6.
If the start up voltage falls below Cold Cathode Tube strike voltage, the CCFL will not light up easily
specially at lower ambient temperature. Please review mounting instruction to avoid any abnormal
operation due to coupling/leakage capacitance of inverter high voltage area to any surrounding conductor.
Power Systems – The Power Solution
Web:
Email:
www.Power-Systems.de
[e-mail]
All specification are subject to change without notice.
Page ( 4 / 4 )
Address: Dörnet 8 ; 74360 Ilsfeld-Auenstein / Germany
Tel. : + 49 / 70 62 / 67 59 - 6
Fax: + 49 / 70 62 / 67 59 - 80
VER, 04 October 2002