PS-DA0143-01 Datasheet, PDF (2/5 Pages) Power Systems GmbH+Co.KG – DC-AC INVERTER UNIT 5 W SINGLE OUTPUT

DC-AC INVERTER UNIT
PS-DA0143-01(S) (5 W SINGLE OUTPUT)
(PRELIMINARY INFORMATION)
Input side CN1:
Pin No. Symbols
CN 1-1
Vin
CN 1-2
GND
CN 1-3
Ext. PWM
CN 1-4
N.C.
CN 1-5
Vrm t
Ratings
10.8~13.2 Vdc
-
0 ~ 1 Vdc Low/ 3~5 Vdc High(L activ)
-
0 ~ 0.4 = OFF / 2.5 ~ 5.5 = ON
Output side CN2
Pin No. Symbols
CN 2-1 Vhigh
CN 2-2
N.C.
CN 2-3
Vlow
Ratings
850Vrms (6mArms)
-
GND
ELECTRICAL CHARACTERISTICS :
Parameters
Conditions
Symbols
Vin (V) Vbr (V) Tu (°C)
Specification
Min. Typ. Max.
Output Current
Output Current
Input Current
Frequency
Open Circuit Voltage
No Load Shotdown
Iout
Iout
Iin
F
Vopen
Ts d
12±1.2
12±0.6
12±1.2
12±1.2
11.4
12±1.2
0.0 -30 ~ +70 5.5
6.0
6.5
5.0 -30 ~ +70 -
20
-
0.0 -30 ~ +70 -
TBD TBD
0.0 -30 ~ +70 50
60
70
0.0 -30 ~ +70 2.200 2.400 2.700
0.0 -30 ~ +70 -
1.0
-
Unit
m Arm s
%
Adc
kHz
Vrm s
sec
Note
Duty 100%
without load
Note 1 :
Note 2:
Note 3:
Please keep minimum of 2mm clearance (all directions) between inverter high voltage area as marked
on mechanical drawing and any conductors.
The external PWM frequency should be in a range of 100 ~ 500 Hz. For other frequency please request.
The optimum is normally at 250 Hz, and minimizes the interference disturbances of the vertical sync.
frequency.
Before apply any control signal into inverter, please provide Vcc first. Please follow the reversed
sequence during power off. Power off control signal first, then power off Vcc.
TEST CIRCUIT :
Vin
12V
A ^Iin
V
F
F
CN1-1
CN1-2
Ext. PWM*
0~1 V Low
3~5 V High
CN1-3
T1
NC
CN1-4
Vrmt
2.5 ~ 5.5 Vdc
V
a
b ^SW1
CN1-5
1000:1
PROBE
CN2-1
SW3
Vopen V~
CN2-2
N.C.
A~ _Iout1
RL1
CL1
CN2-3
SW4
Power Systems – The Power Solution
Web:
Email:
www.Power-Systems.de
[e-mail]
All specifications are subject to change without notice.
Page (2)
Address: Hauptstraße 48 ; 74360 Ilsfeld-Auenstein / Germany
Tel. : + 49 / 70 62 / 67 59 - 6
Fax: + 49 / 70 62 / 67 59 - 800
Version 1.1.6, 24th February 2009