CWS-1202.5A10M Datasheet, PDF (1/4 Pages) Power Systems GmbH+Co.KG – DC-DC Converter UNIT

DC-DC Converter UNIT
CW SERIES (10W~12W Wide Input Range)
FEATURES
•10W to 12W dil package
•9-18V, 18-36V, 36-72V Wide Input Range
•100% Burned in
•High efficiency
•UL 94V-0 Package material
•Costum solutions available
•RoHS compliant
•3 Years warranty
OUTPUT SPECIFICATIONS
Voltage Set point Accuracy
Temperature Coefficient
Ripple & Noise (20MHz BW)¹
Line Regulation²
Load Regulation³
Minimum Load
Short Circuit Protection
Short Circuit Restart
Transient Response⁵
Over Load Protection
+/-2% max
+/-0.05%/ °C
100mVp-p max
+/-0.5% max
+/-0.5% max
20% of Full Load
Continuous
Automatic
350uS max
100% ~180%
ENVIRONMENTAL SPECIFICATIONS
Operating Temperature
Storage Temperature
Case Temperature
-40 °C to +85 °C
-55 °C to +105 °C
95% °C max
Humidity
95% max
Cooling
Free-Air Convection
INPUT SPECIFICATIONS
Input Voltage Range
Input Filter
Protection
2:1 Input Range
Pi Network
Fuse Recommended
GENERAL SPECIFICATIONS
Efficiency
Isolation Voltage⁴
Isolation Resistance
Isolation Capacitance
Switching Frequency
MTBF⁶
Weight
Case Material
Case Size
Potting Material
Conducted Emissions
Radiated Emissions
Remote On / Off
-On
-Off
-Off idle current
78% min
1500 VDC min
10⁹ ohms min
2200pF max
400 KHz Typ
>600,000 Hours
18.5g Typ
Five-sided shield case
31.8mm*20.3mm*12.2mm
Epoxy (UL94-V0)
EN55022 Class A
EN55022 Class A
3.0…12V/DC or open circuit
(referenced to-Vin)
0…1.2V/DC or short circuit
(pin 1 and pin 2/3)
2.5 mA
ALL SPECIFICATIONS TYPICAL AT NOMINAL LINE, FULL LOAD , AND 25 °C UNLESS OTHERWISE NOTED.
[1] Measured with 1uF ceramic capacitor connect to the output pins.
[2] High Line to Low Line.
[3] Load Regulation is for output load current change from 20% to 100%.
[4] 1500Vdc for 10 seconds
[5] 25% Step Load Change.
[6] MIL-HDBK-217F @25 °C , Ground Benign.
Power Systems – The Power Solution
Web:
www.Power-Systems.de
Email:
[e-mail]
All specifications are subject to change without notice.
Page (1)
Address: Hauptstr. 48 ; 74360 Ilsfeld-Auenstein / Germany
Tel. : + 49 / 70 62 / 67 59 - 6
Fax: + 49 / 70 62 / 67 59 - 800
Version 1.0, 20th May 2008