DP8110 Datasheet, PDF (5/34 Pages) Power-One – 8V to 14V Input, 0.7V to 5.5V Output

DP8110 10A DC-DC Intelligent dPOL Data Sheet
8V to 14V Input • 0.7V to 5.5V Output
Type
Threshold
Threshold Accuracy
Delay
Threshold
Threshold Accuracy
Hysteresis
Logic
Lower Threshold
Upper Threshold
Threshold Accuracy
PG On Delay⁶
PG Off Delay
Default
Programmable
Enabled during output voltage ramping up
Disabled
Latching/Non-Latching, 130ms
±250
-50
50
From instant when threshold is exceeded until
the turn-off command is generated
6
Overtemperature Warning
Always enabled, reported in Status register (TW
bit)⁵
110
From Nominal Set Point
-5
+5
1.7
Power Good Signal (PG pin)
VOUT is inside the PG window
VOUT is outside the PG window
Default
Programmable in 5% steps
Default
Programmable in 5% steps
High
Low
90
90
95
110
105
110
Measured at VO.SET=2.5V
-2
2
Default
Programmable at
Default
Programmable same as PG On Delay
0
0, 10, 50, 150
PG disabled when VOUT ≤ VUV
threshold
PG disabled at turn-off command
(Reset function)
mVDC
mVDC
µs
°C
°C
°C
%VO.SET
%VO.SET
%VO.SET
%VO.SET
ms
5 _{Temp Warning error same sign and proportional with OTP error.}
6 _{From instant when threshold is exceeded until status of PG signal changes high}
BCD.00262 Rev. 1.0, 12 FEB 2013
www.power-one.com
Page 5 of 34