FNP600 Datasheet, PDF (1/13 Pages) Power-One – 600-to-5000-Watt Front-End Power Solutions

FNP600/850/1000 AC-DC Front-Ends
& FNR-5-12/FNR-5-48 Power Shelves Data Sheet
600-to-5000-Watt
Front-End Power Solutions
(600, 850, or 1000 Watts)
I²C Management Software: All FNP front-ends
can be controlled via Power-One's GUI-driven I²C
Management software and an I²C-to-USB
interface (P/N HZZ02002G). An I²C Programming
Manual describes the complete range of
parameters that can be programmed to these
front-ends. This manual is available by searching
on "FNP600" at www.power-one.com.
Features
• RoHS lead free solder and lead solder exempted
products are available
• High density front-ends 10.5 to 16.1 W/in³
• Universal input voltage range (90-264 VAC) with PFC
• 1U or 2U height configurations
• Droop current share with ORing FETs
• I²C interface status and control
• Standby voltage of 12 VDC @ 0.5 A
• Overtemperature, overload, and overvoltage protection
• Status LEDs: AC OK, DC OK, Overtemperature
• FNP850-12 model has airflow direction from
front-to-rear or from rear-to-front (-12R model)
Applications
• Telecom
• Datacom
• Distributed power systems
FNR-5 Power Shelf
FNR-5-48 Power Shelves provide up to 5000 watts in a 19" rack.
(See the Rack section for power shelf details.)
Description
The FNP600/850/1000 power factor corrected (PFC) front ends provide (depending on model) either a 12 VDC or a 48 VDC
output for telecom, datacom, and other distributed power applications. Their small 1U by 2U size allows for configurations of
either height in hot-swap redundant systems while their internal fan and cooling design permits wide use with reliable operation.
Status is provided with front panel LEDs, logic signals, and via the I²C management interface bus. In addition, the I²C bus can
enable the power supply, control fan speed, and on the 12 VDC models it allows for adjusting the output voltage from 7 to 12
VDC. This powerful feature allows the same power supply to be used in various applications where bus voltages driving isolated
dc-dc converters and POL regulators may be different.
Also, the FNP850-12R is uniquely designed with airflow from the rear of the power supply to the front. This airflow direction
supports those critical applications where space limitations and/or higher ambient temperatures near the rear of the rack system,
prohibit the discharge of higher temperature airflow from regular front-to-rear cooled power supplies.
The FNP600/850/1000's meet international safety requirements and are CE marked to the Low Voltage Directive (LVD).
FEB 12, 2007 revised to FEB 26, 2007
Page 1 of 13
www.power-one.com